How to Configure AudioCodes MP 114?

1. Quick Setup

1. Enter the “IP Address”: 192.168.0.87(Ex)
2. Enter the “Subnet Mask”:255.255.255.0(Ex)
3. Enter the “Default Gateway IP Address”:192.168.0.2(Ex)
4. Choose the “Working with Proxy”: Yes.
5. Enter the “Proxy IP Address”: 192.168.0.68(Ex)
6. Enable Registration.
7. Click on [Reset] button.

How do I reset my audiocodes?

Restoring Defaults Using the Phone’s Screen Press the Menu key 2. Scroll down to Administration and press OK 3. Enter the Admin password (default 1234) followed by OK 4. Scroll down to Restore Defaults and press OK 5.

How do I reset my audiocodes MP 124?

To restore the device to factory defaults: Disconnect the Ethernet cable and then with a paper clip or any other similar pointed object, press and hold down the button for at least 12 seconds, but no more than 25 seconds.

What is the IP address of AudioCodes mp-114 / 118?

The AudioCodes MP-114/118 VoIP Gateway comes with default network parameters (factory default parameters). The default IP address is 10.1.10.11. You can also load factory network parameters and reset the username and password to its default settings (username: Admin, password: Admin) by following these steps:

How to change the IP address of AudioCodes gateway?

In the ‘IP Settings’ page ( Configuration tab > VoIP menu > Network menu > IP Settings page item) enter the IP Address, Subnet Mask and optionally the Default Gateway Address of the AudioCodes Gateway. Click Submit to apply the changes. Note: The IP address is immediately changed when pressing Submit, but it is not permanently stored.

How to upgrade the software of AudioCodes mp114 gateway?

To upgrade the software of the AudioCodes MP114 gateway, follow these steps: 1 From the Home Page of the Gateway, select Device Actions -> Software Upgrade Wizard 2 Select the button CMP file, and Browse to the software file (.cmp), and select Send File. 3 When the file is successfully loaded, press the Next button. Più articoli…

How to rescue AudioCodes mp114 on a Mac?

A possible rescue is to use the AudioCodes’ BootP program. This program accesses the MP11x using its MAC address and uploads a selected firmware file (cmp) and configuration file (ini file). The BootP program, the cmp-file and the ini-file can be downloaded from the download site. Install and run BootP; Click Edit -> Preferences