What is JIC in army?

A Joint Intelligence Center (JIC) is a focal point for military intelligence gathered by different intelligence agencies and administered by the Defense Intelligence Agency (DIA).

What does JIC stand for in fittings?

Joint Industry Council
JIC (or Joint Industry Council) fittings, defined by SAE J514, are compression fittings machined with a 37 degree flare seating surface and parallel threads. They are commonly manufactured in nickel alloys, brass, carbon & stainless steel.

Is JIC same as flare?

JIC fittings are dimensionally identical to AN (Army-Navy) fittings, but are produced to less exacting tolerances and are generally less costly. SAE 45-degree flare fittings are similar in appearance, but are not interchangeable, though dash sizes 2, 3, 4, 5, 8, 10, 14, and 16 share the same thread size.

Who sits on the JIC?

The JIC’s permanent members are senior officials from Cabinet Office, including the JIC Chairman, the Chief of the Assessments Staff and the National Security Advisor, as well as officials from the Foreign & Commonwealth Office, the Ministry of Defence, the Home Office, the Department for International Development, HM …

What does JIC stand for in hydraulic fittings?

Pipe size is an industry designation, not the actual size. View information about how to measure threaded and unthreaded pipe and pipe fittings. Also known as JIC (Joint Industrial Council) fittings, these provide a tight metal-to-metal seal on stainless steel tubing that is flared to 37°.

What should be the location of a JIC?

The JIC should be located close to the best sources of information, such as an EOC, without compromising safety or security of the personnel staffing the facility. A single JIC location is preferable, but the system is flexible and adaptable enough to accommodate virtual or multiple JIC locations, as required.

Which is JIC fitting converts NPT to JIC?

An JIC bulkhead adapter, which converts National Pipe Thread (NPT) on the left to JIC on the right. The angled seating surface is clearly visible on the far right. JIC fittings, defined by the SAE J514 and MIL-DTL-18866 standards, are a type of flare fitting machined with a 37-degree flare seating surface.

What kind of steel is used for JIC fittings?

Materials commonly used to fabricate JIC fittings include forged carbon steel, forged stainless steel, forged brass, machined brass, Monel and nickel-copper alloys. JIC fittings are commonly used in the Fluid Power industry in a diagnostic and test-point setting.