What is celette bench?

CELETTE is the worldwide leader of “Zero Tolerance” dedicated bench systems, Frame Machine, Universal Jigs and model specific fixture sets – Dedicated Jigs.

What is a celette bench used for?

Both Celette and Car Bench work closely with Daimler AG (Stuttgart) in designing and building dedicated fixture sets for Mercedes-Benz and Maybach vehicles which not only provide for accurate component location, but also provide a safe, proper anchoring of the vehicle during pulling operations.

What is set up and measure?

Many techs I contacted about this issue say setup and measure is lumped into one procedure and includes the setup of the vehicle in the frame machine’s holding system. Very few shops charge additional diagnostic time or access time to remove panels or shields on the underside of the vehicle.

What is a frame rack?

Frame racks provide a superior platform for providing the pulls and pushes that remain integral to proper truck collision repair. For shops that service more cars than trucks, a bench may make more sense. Unibody vehicles often require more parts replacement than pulling.

How much does a car O liner cost?

With the BenchRack and Vision X1 measuring system, shops can Get Started with Car-O-Liner for under $70k.

What is a car frame machine?

Exactly What is an Auto Body Frame Machine? A frame straightening machine consists of a platform large enough to hold a car, SUV or pickup truck, and two or three upright posts or towers that can be rotated 360-degrees and moved along the platform perimeter to work on different areas of a vehicle frame.

How is chassis size measured?

The width dimensions are measured perpendicular to an imaginary line down the center of the vehicle, the Center Line. The width is the total distance from one side of the vehicle to the other divided by 2 unless the point is not symmetrical from side to side then the distance is from centerline.

Is a bench used to pull a vehicle?

Benches hold a vehicle in alignment and allow parts and pieces of the vehicle to be positioned within the alignment of the bench. A bench can have measurement scales running down the platform and along the crossbeams to reference all repairs or dedicated fixtures that are vehicle-specific.

What is a Kansas Jack?

Product Overview. Kansas Jack Power Post Frame Straightening Floor equipment provides space/saving functionality and portability, allowing you to make the most of your shop’s space. Floor pull system utilizes tie-downs which are countersunk in the floor – there when you need them, out of the way when you don’t.

What is a car liner?

A car roof liner is the material that covers the ceiling of a car. It is usually made from polyurethane; this material is perfect for adhering to the roof of the car. A fabric, leather or vinyl is used as a covering for the foam material and it is made with soft fabric and offers a great aesthetic effect on the car.

What makes a Celette bench different from a plateform bench?

Celette bench is unique, more than a plateform system, Celette bench uses an accurate top surface equipped with modular hole, ready to accept MZ and MZ+ jigs system.

Where did Germain Celette make his first bench?

CELETTE began exporting products to GERMANY, and this then developed into exportation to several countries all over the world. Germain CELETTE creates the first bench and dedicated fixture set. This knowledge and experience has been compiled from over 65 years of association with various vehicle manufacturers worldwide.

Where can I rent a Celette bench set?

If you have a Celette bench, it is now possible to rent fixtures set from your nearest celette rental center. If playback doesn’t begin shortly, try restarting your device.

Who is Germain Celette and what do they do?

Germain CELETTE creates the first bench and dedicated fixture set. This knowledge and experience has been compiled from over 65 years of association with various vehicle manufacturers worldwide. The know-how of new designs, build raw materials and joining technologies demand constant update for the Collision Industry.