Why is my car cranking but not starting?
Why is my car cranking but not starting?
When your engine cranks but won’t start or run, it could mean your engine is having trouble producing a spark, getting fuel, or creating compression. The most common causes are problems in the ignition (for example, a bad ignition coil) or fuel system (for example, a clogged fuel filter).
How do you reset the security system on a 2000 Chevy Blazer?
How to reset security
- Turn ON the ignition, with the engine OFF.
- Attempt to start the engine, then release the key to ON (vehicle will not start).
- Observe the SECURITY telltale light, after approximately 10 minutes the telltale will turn OFF.
- Turn OFF the ignition, and wait 5 seconds.
How much is an ignition switch for a 2000 Chevy Blazer?
The average cost for a Chevrolet Blazer ignition switch replacement is between $275 and $345. Labor costs are estimated between $154 and $194 while parts are priced between $121 and $150.
Why does my 1999 Chevy Blazer not start?
I have a,1999 blazer I put a new battery in. And now it the three or four times to start after I get it started in don’t have a problem starting it all day New fuel pump, pressure is good. New programed ecm, new delco spider. , still injectors are not emitting fuel. Starter fluid will fire the engine but won’t stay running.
What causes a Chevy Blazer to shut off while driving?
Sudendly looses power and shuts off while driving… Coolant or antifreeze Oil Fuel pump Fuel filter Battery Fuses For two week’s prior to incident when i shut off the truck i could hear a boiling like sound coming from the coolant resivoir.
Can a 93 K5 Blazer 5.7 start when cold?
My 93 k5 blazer 5.7 will start and run fine when the engine is cold. After it warms up it dies. Try to start it again and it sounds like it tries to start then the starter will bog and sometimes it turns over fine but just won’t start until it cools down.
Why does my car not turn on when I start it?
When you try to start running the engine or press start, the vehicle won’t turn on. The engine simply turns but it does not work as it should. Check the ignition module, located in the distrbutor and check as well the sparking. I’ve already found the problem.