How do you wrap a new Macbook charger?

Take your large Macbook cord (the one that plugs into the wall) and plug one end of the large cord into the base of your charger. Route the cable on one side of the spot where the small cord meets the charger. Then wrap the cord around the charger from top to bottom.

How can I make my Macbook charger last longer?

Properly disconnecting the MagSafe connector from the computer can prolong the life of the adapter. Disconnect using the connector itself instead of the cord, as discussed in the article about using and maintaining your Apple MagSafe Adapter.

How do you use an Apple extension cord?

1 Answer from the Community Take your Power Adapter and slide the 2 prong plug off. You will see the same connection as the Power Adapter Extension Cable. Slide the Extension Cable into the Power Adapter and you now have a a cable capable of reaching those hard to reach wall plugs.

Why do they wrap power cord around MacBook?

Apple is known for its attention to detail, and that focus on the little things is probably why it sells its MacBooks with power bricks that have flick-out wings for wrapping the cord around. It’s not a big thing, but it’s just enough to make lugging a notebook computer around just that little bit easier.

What’s the best way to wrap a charger?

Route the cable on one side of the spot where the small cord meets the charger. Then wrap the cord around the charger from top to bottom. Until you’ve finished the wrapping process, just hold the wrapped large cord in place with one hand. Wrap the small cord around the two collapsible clips.

What’s the best way to charge a MacBook Air?

Think of this as the “top” of the Macbook charger. Take your large Macbook cord (the one that plugs into the wall) and plug 1 end of the large cord into the base of your charger. Route the cable on 1 side or the other of the spot where the small cord meets the charger. Then wrap the cord around the charger from top to bottom.

Where is the Charger cord on a MacBook Pro?

Look closely between the corners on either side of the spot where your Macbook charger meets the cord. You should see a pair of small clips, or wings. Use your fingernail to open these so that they stand out at a 90-degree angle from the body of the charger.