How do I reset my HP Laserjet p4515x to factory settings?

hp repair service

1. Press Menu .
2. Press the down arrow to highlight CONFIGURE DEVICE, and then press OK.
3. Press the down arrow to highlight RESETS, and then press OK.
4. Press the down arrow to highlight RESTORE FACTORY SETTINGS, and then press OK.

How do I reset my HP Laserjet printer to factory settings?

To restore the product to the factory-default settings, follow these steps.

1. Turn the product off. Disconnect the power cable from the product for 30 seconds and then reconnect.
2. Turn the product on while you press and hold the Resume button for 10-20 seconds. The Attention light turns on.
3. Release the Resume button.

How to do a cold reset on a LaserJet p4515?

NVRAM only when absolutely necessary. In most situations, use a cold reset to reset product variables but still retain the needed values in the SERVICE menu. 1. Turn the product on and watch the control panel display. 2. When the display shows the memory count, press and hold the down arrow until all three lights on the control panel are lit. 3.

How do you do a cold reset on a HP printer?

Initialize NVRAM only when absolutely necessary. In most situations, use a cold reset to reset product variables but still retain the needed values in the SERVICE menu. 1. Turn the product on and watch the control panel display. 2. When the display shows the memory count, press and hold the down arrow until all three lights

How to reset a HP LaserJet p4015dn printer?

1. Turn the printer to the “off” position. 2. Power on the printer. 3. Press and hold down the “OK” button while the memory is counting. The memory begins counting at 000MB immediately after you power on the device. 4. Continue to hold down the “OK” button until all three LEDs are illuminated. 5. Release the OK button. 6.

How to reset the maintenance count on a HP printer?

After installing a maintenance kit, you should reset the printer’s “Maintenance Count.” There are two ways to do this, depending on your firmware version. 1. Turn the printer to the “off” position. 2. Power on the printer. 3. Press and hold down the “OK” button while the memory is counting.