How do you apply raw Osmo oil?

Method of Application With Osmo Flat Brush, Floor Brush or Osmo Microfibre Roller, apply thinly along the wood grain and spread well. Applying excess Polyx®-Oil Effect Raw 3044 may lead to a white chalky surface. Remove visible white pigments before allowing the surface to dry. Allow to dry for approx.

Can you buff Osmo polyx oil?

Remove excess immediately. Alternatively, apply second coat by trowel and buff the surface with a white pad. Leave to dry 8-10 hours, ventilate well. When thoroughly dry, surface can be buffed or polished with hand polisher or buffing machine.

How does Osmo POLYX oil 3044 raw work?

Osmo Polyx®-Oil 3044 Raw is designed to retain this appearance by using a small amount of white pigments to neutralise the permanent ‘wet-look’ that develops after application of a clear finish. Apply very thinly to achieve the desired results.

When to apply Osmo Hardwax oil to wood?

APPLICATION: • Apply in two coats. On each coat, 1 liter of OSMO Hardwax Oil covers 200 -250 square feet depending on wood density and final grit. • For ideal application, apply when the room is 60 to 75 degrees Fahrenheit. Relative humidity should be below 50 percent. A lower temperature or a higher relative humidity may slow drying.

What kind of POLYX oil to use on wood?

Clear Polyx Oil will bring out the natural tone and patina of the wood, enhancing the grain giving it will appear darker and what we call the “wet look”. If this isn’t for you, then we recommend the Osmo Polyx Oil Raw 3044. This will lessen the wet look on lighter timbers such as Oak or Pine.

How often should you apply Osmo exterior protection?

Although it does look awesome, you must apply additional coats and then re-coat it every year. They can’t claim “exterior protection” if the coating itself fails after such a short time, surly?