How do I set my La Crosse Technology Atomic clock?

Press and hold the SET button for 3+ seconds to activate the manual mode. Once the clock is in manual mode, there are two ways to move the minute hand forward. 2. Hold the SET button down to move the minute hand forward consistently.

How do I reset my LaCrosse atomic wall clock?

Hold the WAVE button down for 3+ seconds. The hands will automatically reset to the 12:00 position, and the clock will search for the WWVB time signal. If the clock receives the signal, the clock will set automatically to the correct time.

How do I reset my atomic clock?

Atomic Clocks may also be set manually and be very accurate. Simply insert the battery, press your time zone and then press the flap just above the left side of the battery. Hold until you reach the correct time and then release.

How long does it take an atomic clock to set?

When you turn a radio controlled clock on, it will probably miss the first time code, so it usually takes more than one minute to set itself (sometimes 5 minutes or longer) depending on the signal quality and the receiver design.

Will an atomic clock set itself?

Atomic clocks set themselves and automatically adjust for daylight saving time to provide the most accurate timekeeping standard possible. 1. Locate the Time Zone Switch (E) on the back of the clock.

Why is my atomic clock losing time?

If an atomic radio controlled clock isn’t currently receiving the WWVB atomic clock synch signal, it’s time display will gradually “drift” away from the correct time. This could cause the clock to be off by a second or more even if it is receiving the atomic clock synch signal properly.

Why hasn’t my atomic clock changed time?

It is possible the clock is in an area with a lot of wireless interference. If your clock did not change with Daylight Savings Time (DST), make sure the DST switch on the back of the clock is set to ON. If your clock is off by increments of an hour, the Time Zone (TZ) is set incorrectly.

Why did my atomic clock lose an hour?

If the atomic radio controlled clock is off by one or more hours, it probably has to do with the time zone setting. Make sure the time zone has been properly selected using the instructions that came with the clock. When purchasing a clock, make sure that it can display the correct time zone.