How do I troubleshoot my Samsung front load washer?

Troubleshooting

1. Unplug the machine.
2. Disconnect the hoses.
3. Remove the detergent drawer by pressing the central locking button.
4. Open the hatch of the drain filter at the bottom of the front panel.
5. Empty the water and clean the filter.
6. Put the washer on a side so that you can access the bottom.

How do I troubleshoot my Samsung washer?

SAMSUNG WASHER FIX/SOLUTION:

1. Check the fuse or reset the circuit breaker.
2. Straighten the drain hoses.
3. Eliminate kinked hoses.
4. If there is a drain restriction, troubleshoot it.
5. Close the door and press the Start/Pause button.
6. For your safety, your washer will not tumble or spin unless the door is closed.

Does a Samsung washer have a reset button?

To reset your Samsung washing machine you need to simply disconnect the washing machine from power for 5 to 10 minutes. Once the 5 to 10 minutes has passed, connect power to your Samsung washer and run a test wash load to see if the error code has cleared.

How do I reset my Samsung front load washer?

Resetting your washing machine is easy. Unplug it (or turn off power at the circuit breaker), wait some time for the electrical charge to clear out of the washer (usually 1 to 5 minutes at most), and then power it up again. That’s it. That’s all it takes to reset.

How do I run a diagnostic on my Samsung front load washing machine?

On most Samsung front loading washers you enter diagnostics mode by Pushing the “Signal” button and the “Extra Rinse” button. Push the “Spin” button and when “d” is shown on the display panel, turn or jog the dial in a clockwise or counter clockwise motion and you can then see error codes that have happened recently.

What do you do if your Samsung washer won’t drain?

More videos on YouTube

1. Turn off the washer and check the level. If the washer isn’t level it may not drain correctly.
2. Inspect the drain hose.
3. Clean the pump filter (front loaders only).
4. Turn the washer back on and start a cycle.

What would cause a front load washer not to spin?

Front-load washer tubs spin thanks to a drive belt that runs off of the motor. A loose, frayed, or torn belt could be why your washer won’t spin. Overloading your washing machine can cause the belt to loosen or become worn out. Inspect the drive belt closely.

How do you reset a Samsung front load washer?

How do you reset a Samsung washer?

Is there a recall on the Samsung front load washer?

There has been a recall on Samsung front load washers because water leakage onto the electrical connections of the washing machine’s thermal sensor could cause an electrical short and ignite a circuit board, posing a fire hazard to consumers.

What to do if your Samsung washer is not working?

Solution: STOP using the washer until you can check into the recall and/or have the electrical system of your washer checked. If you need a user or repair manual, you can find it here. Problem: After every load of laundry, water remains in the detergent dispenser tray.

How much detergent to use in a Samsung washer?

One teaspoon of concentrated HE detergent is the recommended amount for a small, cold water load. Never use more than two teaspoons in a HE washer no matter the load size or water temperature. Rewashing the clothes on a warm water wash cycle with no added detergent should remove the streaks.

What does out of balance do on a Samsung washer?

Today’s washers have out of balance protection installed to protect a washer from damaging itself during the spin cycle. Some Samsung washers add more water during the spin cycle to attempt to correct the imbalance of a small load. To solve the problem, redistribute clothes to better balance the washer. If…