How much does a water pump cost for a Chrysler Sebring?

The Best in Auto Repair The average cost for a Chrysler Sebring water pump replacement is between $600 and $717. Labor costs are estimated between $448 and $565 while parts are priced at $152.

How do you reset the timing chain on a 2.7 tensioner?

Reset the timing chain tensioner by positioning cylinder plunger into deeper end of the tool #8186. 6. Apply a downward force until tensioner is reset. Note: If oil was not first purged from the tensioner, use light finger pressure to assist the center arm of tool #8186 to unseat the tensioner check ball.

How much is a water pump for a 2008 Chrysler Sebring?

2008 Chrysler Sebring Water Pump – from $44.99+ | AutoZone.com.

How much is a water pump for a 2007 Chrysler Sebring?

2007 Chrysler Sebring Water Pump – from $44.99+ | AutoZone.com.

What does it cost to replace the water pump?

The average water pump replacement cost is $550, with prices ranging from $461 to $638 in the US in 2020. But typically depends on the type of vehicle you drive and the auto repair shop you take it to. Labor costs are between $256 and $324 while parts cost between $205 and $314.

How much is a water pump for a Chrysler 300?

Chrysler 300 Water Pump Replacement Cost Estimate. Labor costs are estimated between $238 and $300 while parts are priced between $167 and $168. This range is based on the number and age of Chrysler 300’s on the road.

Are 2.7 engines bad?

According to the Chrysler lawsuits, due to its faulty design, the 2.7 was prone to oil sludge, which could cause the engine to fail a lot earlier than it should or was to be expected. The engine was found to fail around the 50,000 to 60,000 miles mark. In some cases, the engine would fail around 20,000 miles.

How much is a water pump for a Dodge Stratus?

The average cost for a Dodge Stratus water pump replacement is between $531 and $638. Labor costs are estimated between $410 and $517 while parts are priced at $121.

Where is the water pump located on a 2001 Dodge Stratus?

The water pump is behind the timing cover. Esssentially – you need to remove (replace) the timing belt to replace the water pump. This is not a very easy do-it-yourself job unless you are an experienced technician.