Where is the speed sensor located on a Harley Davidson?

Harley-Davidson Sportster 883 and 1200 models use a special sensor to detect the motorcycle’s speed, providing greater accuracy than the steel cable used on earlier models. This vehicle speed sensor is attached to the engine’s crankcase, behind the rear cylinder and the starter motor.

Can you change the speed sensor?

Replacing Your Transmission Speed Sensors Having found the sensor or sensors to be faulty, remove the connector between the sensor and the vehicle’s wiring. Using the proper socket, remove the faulty sensor. Connect the new sensor to the vehicle’s wiring. Install the new sensor.

What is VSS on a Harley?

Symptoms of a Faulty VSS (Vehicle Speed Sensor)? – Harley Davidson Forums.

How do I reset my Harley speedometer?

To reset the trip-odometer to zero, press button to reset speedometer display to the ODOMETER mode and hold the button in for approximately 2 to 3 seconds. The speedometer will switch to the trip-odometer mode and reset the display to zero.

How do you change a speed sensor on a Harley Davidson?

Harley Davidson Softail: How to Replace Speed Sensor

1. Step 1 – Locate the speed sensor.
2. Step 2 – Remove splash guard.
3. Step 3 – Remove electrical components.
4. Step 4 – Remove the speed sensor.
5. Step 5 – Install new speed sensor.
6. Featured Video: Speed Sensor Removal and Replacement.
7. Related Discussions.

What is the difference between vehicle speed sensor and transmission speed sensor?

The vehicle speed sensor (VSS) is also commonly referred to as a transmission speed sensor or output shaft speed sensor. It is a small device—typically mounted somewhere on the transmission—that determines how fast your vehicle is going by measuring the rotation of a toothed wheel on a shaft inside the transmission.

Why does my speedometer stop working?

If your speedometer stopped working and stays at 0 MPH, you should have your car checked ASAP. The most common causes of a speedometer that stopped working include are a faulty speed sensor, a broken gear on the speedometer, damaged wiring, or a faulty engine control unit.

How to fix a speed sensor on a Harley Davidson?

Easy Fix for Harley Davidson SPEEDOMETER speed sensor clean metal shavings 5 minute repair turn signals not auto canceling reading low high repair replace magnet 2002 dyna lowrider TC88 motorcycle engine kawasaki yamaha suzuki honda Loading…

Where is the speed sensor located on a Dyna Wide Glide?

I have a 2007 dyna wide glide, where is the speed sensor located? I do not have a service manual. Behind the transmission top cover and near the starter. Had the same problem on my 2000 ultra. Had to change to what my mechanic called a maxi fuse. The one under the seat left side that has the starter wires to it.

How to replace the speed sensor on a Softail?

Harley Davidson Softail: How to Replace Speed Sensor. 1 Step 1 – Locate the speed sensor. If you have never worked on a Harley before, you might assume the speed sensor is on the front or back wheel, but 2 Step 2 – Remove splash guard. 3 Step 5 – Install new speed sensor.

What happens when the speed sensor goes bad?

When the speed sensor goes bad, you can experience one of two issues: your speedometer could start acting strange, where it fluctuates in a mad matter, or your speedometer could stop working completely. You may also notice your turn signals no longer turn themselves off after a turn. Erratic idling has been reported, as well.