Where is the OBD port in a Ford Mondeo?

OBD connector location for Ford Mondeo 3 Mk4 (2007 – 2014)

1. The connector is on the left under the steering wheel.
2. Open the spare box which is at the left of the steering wheel.
3. Open the cover, the plug is behind it.
4. OBD connector.

Where is the OBD connector located?

The OBD-II port is usually located under the dashboard, beneath the steering wheel column (1 – 3 in the diagram below).

Where is the OBD port on a 2003 Ford Fusion?

OBD connector location for Ford Fusion (2002 – 2005)

1. Under steering wheel at the left.
2. OBD Connector is near the pedals (watch from bottom)
3. OBD Connector.

Where is the OBD2 fuse located?

One under the hood, one in the trunk and another behind the dashboard. The OBD fuse may be listed on the fuse cover as OBD II, DLC, Accessory port, 12 v power point or cigarette lighter and will most likely be located inside the vehicle. The most efficient way to locate it is check the drivers manual.

How do you reset the service light on a Ford Mondeo?

Reset oil service light Ford Mondeo

1. Get in the vehicle ensure all doors are closed.
2. Then press both the accelerator and the brake pedal and hold them down.
3. Then switch the ignition ON, do not start the engine.
4. .
5. Now wait 15 seconds.
6. .
7. Take feet of pedals.
8. Press ok to close.

What year did OBD start?

On-Board Diagnostic (OBD) systems are integrated into the computers of new vehicles to monitor emissions controls. The first generation of OBD requirements were implemented in California in 1988 and were required on all 1991 and newer vehicles.

Can you use a code reader on a car that won’t start?

If the car is cranking, but won’t start, use an OBD2 scanner to find out if there are any stored trouble codes in the trouble code memory. Most cars after 1998 have an OBD2 system which makes it very easy to read the trouble codes. You can find the information about the trouble codes in OBD2 codes.

Where is the OBD2 port in my Ford Mondeo 2?

Where is the OBD2 port in my Ford Mondeo 2 (2000 – 2007) All vehicles are equipped with an OBD port to which you can connect your klavkarr diagnostic case. Sometimes, the most difficult thing is to find this port! In order to save you time, we have made available (for free) the information uploaded by our community of tens of thousands of users.

Is there a cheap fault code reader for a Ford Mondeo?

Anyone know of a cheap fault code reader that will cover my 2003 TDCi mondeo. Although it has a 16pin OBDC II socket it will not read to a OBDC II reader. Suspect this is because it is pre 2004 when Euro cars were included. Car was first registered in June 2003.

How to reset the OBDII monitor in Ford?

For best results, follow each of the following steps as accurately as possible: 1. Install scan tool. Turn key on with the engine off. Cycle key off, then on. Select appropriate Vehicle & Engine qualifier. Clear all DTC’s/ Perform a PCM Reset. Bypasses engine soak timer. Resets OBDII Monitor status. 2.

What are the codes for Ford OBD-2 trouble codes?

I have a 2014 E350 Superduty chassis that has an RV on the back. I have a P0642 Code – Sensor Reference Voltage “A” Circuit Low. I also had a U0109 Lost Comm to Fuel Pump Control Module. I replaced the Fuel Pump Module and cleared the codes and the