What should the jumper settings be on a new Maxtor hard drive?
What should the jumper settings be on a new Maxtor hard drive?
If your existing drive is set for “Cable Select”, then set your new drive to “Cable Select” also. You can change the existing jumper settings on the original drive to suit your needs, but we recommend following these instructions fi rst to verify proper operation of the new hard drive.
How do I jumper a Seagate Maxtor ATA drive?
If you are connecting the drive to an older system that has a pre-UDMA Mode 3 ATA controller, or you are connecting this to a cable with a slave device that doesn’t have a cable select jumper setting, jumper the drive as Master instead by putting a jumper on the first vertical set of pins closest to the data cable.
How to set jumper block on Maxtor ATA?
If you are unable to match your drive jumper block to one of the styles shown, refer to the jumper settings dia- gram on the drive label. 2. Configure the drive as cable select (CS) by using pliers to move the jumper into the appropriate position on the jumper block.
What do I need to install a Maxtor hard drive?
The Maxtor Hard Drive Kit includes the components shown in Figure 1. Your computer may need some or all of these parts to complete the installation. You will also need the tools shown in Figure 2 on page 2 including a full version of your operating system to install the hard drive in your computer. Handling the Hard Drive
Is the Maxtor d740x-6l a registered trademark?
are registered trademarks of Maxtor Corporation, registered in the U.S.A. and other countries. Maxtor D740X-6L, AutoTransfer, AutoRead, AutoWrite, DisCache, Dis- kWare, Defect Free Interface, and WriteCache are trademarks of Maxtor Corporation. All other brand names or trademarks are the property of their manufacturers.
Where can I get a Seagate Maxtor hard drive?
2190 Miller Drive Longmont, Colorado 80501 Tel: 303-651-6000 Fax: 303-678-2165 Thank you for your interest in Maxtor hard disk drives. This manual provides technical information for OEM engineers and systems integrators regarding the installation and use of Maxtor hard drives.