What is the command to show IP routing table?

show ip route EXEC command
Use the show ip route EXEC command to display the current state of the routing table.

How do I display routing table?

To display the kernel routing table, you can use any of the following methods:

1. route. $ sudo route -n. Kernel IP routing table. Destination Gateway Genmask Flags Metric Ref Use Iface.
2. netstat. $ netstat -rn. Kernel IP routing table.
3. ip. $ ip route list. 192.168.0.0/24 dev eth0 proto kernel scope link src 192.168.0.103.

How do I show IP routes?

To display the current state of the routing table, use the show ip route command in user EXEC or privileged EXEC mode. The show ip route command is a powerful tool to use at this point in your search. You can directly examine the routing table to determine if an entry for the host exists.

How to check the routing table in Cisco?

It is crucial that you know how to check the routing table to see if you have all the routes needed for complete network communication to take place. The “ show ip route” command is one of the most important commands related to routing on Cisco IOS devices in order to show the routing table of the router.

What is the Cisco show ip route command?

The “ show ip route” command is one of the most important commands related to routing on Cisco IOS devices.

Is there a command to show IPv6 sockets?

Support for IPv6 socket information in the display output of the command was added. This command was integrated into Cisco IOS Release 12.0 (21)ST. This command was integrated into Cisco IOS Release 12.0 (22)S.

What’s the command line interface guide for Cisco?

Cisco Unified Communications Manager (CallManager) Maintain and Operate Guides Command Line Interface Guide for Cisco Unified Communications Solutions, Release 11.0(1) Book Contents Book Contents Preface About CLI Delete Commands File Commands License Commands Run Commands Set Commands Show Commands Unset Commands Utils Commands