How do you reset the salt level on Aqua Rite?
How do you reset the salt level on Aqua Rite?
To reset, move the switch to ‘Off’ and then back to ‘Auto’. Wait for the relay to click (5 to 10 seconds). When the instant salt level is stable (and the negative sign still present), slide switch to ‘Super Chlorinate’ and back to ‘Auto’. It takes about 30 seconds for the unit to settle back on the default reading.
How do you check the salt level on Aqua Rite?
The Hayward Aqua Rite Salt Chlorine Generator displays a total of 9 diagnostic parameters that are accessed by pushing the Diagnostic button sequentially. The default display is the Average Salt Level. If the button is not pushed for 30 seconds, the display will revert back to this salt display.
How to reset the salt level on Aqua rite?
Cycle slide Main Switch from Auto Super Chlorinate Auto The Average Salt level needs to be reset for start up and when a cell is replaced. (factory default is 2800ppm) Press Diagnostics button 5 times to display Instant Salt level. Wait for the number to settle. To reset, turn the unit to Off and then back to Auto.
How to turn off the chlorinator on Aqua rite?
Before operation, the Aqua Rite must be co nfigured for the chlorinator cell that will be used. “t-15” is the factory default. If the incorrect cell is chosen the salt level, amperage, and voltage will not be correct and the system will turn the chlorinator off. Slide the Main Switch to the “Auto” position.
Where can I find the Aqua rite diagnostics manual?
Aqua Rite & Aqua Rite XL Diagnostics Manual AQUA RITE ELECTRONIC CHLORINE GENERÀTOR CELL Turbo Cell & Control Electronics Software Revision 1.50 O HAYWARD Copyright 2009 Hayward Industries Inc.
What are the special requirements for an aqua rite pool?
The only special requirements for the Aqua Rite are the salt level and stabilizer. It is important to maintain these levels in order to prevent corrosion or scaling and to ensure maximum enjoyment of the pool. Page 6 Salt Level Use the chart on page 4 to determine how much salt in pounds or (Kgs) need to be added to reach the recommended levels.