How do you calibrate Traktor Scratch?

HOW TO CALIBRATE

1. Open the scratch panel and switch to scope mode.
2. Drop the needle onto the timecode vinyl or start playback of the timecode CD.
3. Click the RST button. The calibration process only takes some seconds.
4. Check if the calibration circle is okay.

How do you recalibrate Traktor S4?

Solution

1. With the S4 MK3 connected to your computer, open TRAKTOR’s Preferences.
2. Navigate to the Traktor S4 MK3 entry at the bottom of the menu.
3. If you want to recalibrate the 4 FX1 and 4 FX2 knobs, click the Recalibrate button corresponding to Upper FX Units.
4. Follow the onscreen prompts to complete the recalibration.

Is Traktor S4 a stand alone mixer?

1. Can I use the TRAKTOR KONTROL S4 as a standalone mixer? The S4 can be used in the alternative standalone mixer mode without a computer. This means you can mix external audio such as turntables on the S4.

What is Traktor headroom?

Headroom. In external mixing mode, TRAKTOR applies a fix headroom value of -3dB for each channel. This allows for a greater freedom to add additional Decks or effects without overdriving the signal.

How do you calibrate Traktor?

Follow the steps below to run the software calibration for the faders or knobs:

1. Open the TRAKTOR Preferences > Traktor Kontrol *controller model*
2. Under Calibration, click on the Recalibrate button next to the control you wish to calibrate.

How to setup a Traktor Scratch Pro 2?

Run the Setup Wizard by clicking on the Setup Wizard button in the lower left corner of the TRAKTOR Preferences. In the DECK LAYOUT SELECTION, choose 2 Track Decks (Scratch). When the Setup Wizard is finished, open the TRAKTOR Preferences and go to Audio Setup. Make sure your audio interface is selected in the Audio Device menu.

How to enable relative mode in Traktor Scratch Pro?

Click on the letter of each Deck (A and B) and select Scratch Control from the drop-down menu. Enable either Relative Mode or Absolute Mode by clicking on one of the respective symbols below the deck. For more information on this, refer to the chapter ‘Tracking Modes’ in the Traktor Application Reference Manual.

Where to find soundcard settings in Traktor Pro?

The Audio Setup window is where you choose and configure your soundcard settings. In the Audio Device menu, you choose what soundcard you’re using (i.e. Traktor Audio 10, Traktor Kontrol S4, etc.) If you don’t have a soundcard connected, you can always use your computers built in soundcard.

How to setup 2 track decks on Kontrol S4 Mk1?

Note: On the KONTROL S4 MK1, do not connect a microphone to the MIC input next to the input channel D as it will override the already established connection. Run the Setup Wizard by clicking on the Setup Wizard button in the lower left corner of the TRAKTOR Preferences. Choose 2 Track Decks (Scratch) when asked for your preferred Deck layout.