Useful tips

Where is the EGR valve on a 2006 Dodge Durango?

Where is the EGR valve on a 2006 Dodge Durango?

Where is EGR valve located in 2006 Dodge Durango V8 Hemi? EGR valve is located under the AirFilter box just below the alternator.

Where is the EGR valve on a 2007 Dodge Durango?

Locate the EGR valve. Look at the front of intake manifold. The EGR valve will be bolted to the intake manifold just in front of the carburetor.

How do you change a EGR valve on a 2005 Dodge Durango?

loosen the 8mm bolts that hold the egr intake tube to the egr valve, remove the egr bolts, disconnect wiring, remove valve and tube together, attach intake tube loosely to new valve, install new valve, tighten tube bolts to egr using a swivel socket, this is not a 5 minute job, so dont attempt unless you have some time …

What happens when an EGR valve fails on a Dodge Ram?

When electrical or mechanical EGR valve failures occur, problems such as poor acceleration and reduced fuel economy can result. The EGR valve is an electronic solenoid that moves a pintle, opening and closing a passageway for exhaust gas to flow through.

Where is the EGR plug on a Dodge Ram?

At the top of the valve you will see a black electrical connector plug with a red tab. Push the red tab to the right to unlock it, and then squeeze the flexible tab on the connector plug while pulling it away from the valve. Now, remove the exhaust hose from the EGR valve. There are two bolts with 8mm heads.

Where is the EGR valve located on a Honda Accord?

There are a total of four bolts: one is on the connector attached to the valve. The 4.7/3.7’s EGR valve is located on the rear of the driver’s side cylinder head, making it very hard to change without removing the resonator box. Refer to Step 1 of the Related Article: How to Replace Ignition Coils and Spark Plugs for this procedure.

Where is the intake valve on a Dodge Ram?

The valve is bolted to the intake manifold/cylinder head and a metal hose connects it to the exhaust manifold/intake manifold. An electrical connector sends and receives signals to the PCM (powertrain control module) to control the valves movement for optimal emissions.