What PSI should the oxygen tank be at for cutting?

But as a rule, more pressure for both oxygen and acetylene is needed for bigger-sized cutting tips. In case the recommended working pressure settings are not indicated, safe numbers are 40 psi for oxygen and 10 psi for acetylene, regardless of cutting tip size.

What are the oxygen pressures for cutting and welding?

The oxygen pressure ranges between 0.7 to 2.8 bar (10 to 40 psi), depending on the size of the torch tip.

What is the best way to set the oxygen pressure for cutting?

What is the best way to set the oxygen pressure for cutting? Increase the pressure slowly and readjust the flame as you watch the length of the clear cutting stream in the center of the flame.

How much pressure is in a full bottle of oxygen?

A full cylinder will read about 2000 psi (pounds per square inch). the gauge reaches the flow rate your doctor prescribed. the regulator. Secure oxygen cylinders in your vehicle so they do not roll or bump against other cylinders or objects.

What should the pressure be on an oxy cutting torch?

Turn the adjusting screw on the regulator until it releases acetylene and the gauge shows 10 psi. Find the oxygen valve of the cutting torch and open it slightly to allow oxygen to flow. Do the same for the cutting torch’s acetylene valve but do not open it by more than 45 degrees or a 1/8 turn.

How much oxygen does it take to cut a slice?

• The oxygen consumption rate for the SLICE cutting rods at 80 psi is 7 to 7.5 cfm for the 6.4 mm diameter cutting rods and 11 to 12 cfm for the 9.5 mm diameter cutting rods. This rate will vary if a different operating pressure is used.

What should the purity of oxygen be for gas cutting?

Generally on material thickness of 50 mm the kerf width can be maintained within ± 0.4 mm. Oxygen used for oxy-fuel gas cutting should have a purity of at least 99.5%.

What should the operating pressure be for exothermic cutting?

Operating Instructions –Oxygen Usage This cutting process uses standard industrial grade oxygen to support the exothermic reaction and to remove the molten metal. • The recommended operating pressure is 80 psi. Applications such as cutting material sections 76.2 mm and thicker might require higher operating pressures.