What is Renderoc Plug?

Renderoc Plug are rapid setting mortars which are easy to apply to horizontal, vertical or overhead surfaces at a wide range of thicknesses. There are two grades available: Renderoc Plug 1 with an initial set time of approximately 1 minute, and Renderoc Plug 20 with an initial set time of approximately 20 minutes.

How do I mix fosroc Renderoc?

If mixing small quantities by hand, Renderoc FC should be volume-batched. Add 3 volumes of the Renderoc FC powder (loose-filled to excess and struck off level with the top of the measuring container) to one volume of potable water. This should be mixed vigorously until fully homogeneous.

What is Renderoc RG?

Renderoc RG is used for repairs to damaged reinforced con- crete elements, particularly where access is restricted and where vibration of the placed material is difficult or impossible.

How do I install Renderoc plugins?

Renderoc Plug should be added to clean water in the following proportions: One part clean water to three parts Renderoc Plug (by volume). Trowel apply or hand-knead the mixed mortar in place, ensuring maximum contact with the substrate before the material sets.

How do I use Cebex 100?

Slowly add the cement (and sand if required) and Cebex 100. Mix continuously for 5 minutes, making sure that a smooth even consistency is obtained. Areas to be grouted should be prepared to ensure substrates are clean, sound, and then pre-wetted. The unrestrained surface area of the grout must be kept to a minimum.

How do I use Renderoc?

How do you mix a Cebex 100?

The selected water content should be accurately measured into the mixer. Slowly add the cement (and sand if required) and Cebex 100. Mix continuously for 5 minutes, making sure that a smooth even consistency is obtained. Areas to be grouted should be prepared to ensure substrates are clean, sound, and then pre-wetted.

What is Nitobond AR?

Nitobond AR is a modified acrylic emulsion specially designed for use as a bonding aid and gauging liquid for cementitious systems. It is resistant to hydrolysis and can therefore be used for external applications. Nitobond AR is the recommended primer for the Fosroc ce- mentitious repair system.

What is BondCrete used for?

BondCrete in its undiluted form provides a ready to use, non toxic, non staining adhesive for carpentry, joinery and general craft work. BondCrete is so strong there is seldom any need to hack chip or acid etch the surfaces to be bonded eg. Concrete, bricks, tiles, plaster, stone, timber, ceramics, metal, fabric etc.

Does concrete adhere to concrete?

QUIKRETE® Concrete Bonding Adhesive (No. 9902) permanently bonds new concrete, plaster, and stucco to existing concrete, plaster, and stucco. Eliminates the need for roughing the surface before the application.