What is gutter apron flashing?

A gutter apron is a bent piece of flashing that tucks up under the shingles and over the gutter. If there’s a drip edge installed where the fascia meets your shingles and the gutter is hung below the drip edge, get some roll flashing and tuck it up under the drip edge and over the top of the gutter.

What’s the difference between drip edge and gutter apron?

Drip edge is installed to the trim of the roof so that it hangs directly behind the back end of the gutter. A gutter apron, on the other hand, is installed under the shingles (See our blog: “What Types of Shingles are Best?”) and above roof decking.

Do you need drip edge and gutter apron?

Used to direct water into the gutter system. They protect your fascia board from water that could wood rot. In most states, it is not required to have a Drip Edge or a Gutter Apron but it is highly recommended.

What is a apron flashing used for?

Apron Inverted Flashing They are a combination base and cap flashing that are usually installed behind the siding and caps and over the sloped roofing materials. An Apron Flashing is responsible for diverting water from a vertical surface into a gutter system.

How much does it cost to install gutter apron?

Installing a gutter drip edge and gutter apron are cost-effective roofing materials ranging between $1 to $3 per linear foot. Unless you choose a more expensive material, then it would also mean a more costly installation, but aside from that, there isn’t a huge difference between the two.

Can you install drip edge after gutters?

However, the drip edge can be installed at any time. The materials involved include: a ladder, a flat pry bar, a hammer, tin snips, eave stripping, and galvanized roofing nails. Something else to consider is the drip edge eave strip, which is often made of galvanized metal.

Is drip edge required by code?

Without a drip edge, water may end up beneath the shingles and may cause damage to various parts of the home. Though your home may not have originally had a drip edge installed, drip edges are now required by most building codes across North America to protect homes from damage.

What is the difference between flashing and drip edge?

The drip edges main function on the eaves is to help the water drip over the roof, away from the facia and into the gutters. The metal flashing has a small metal flange that wicks water back to make a drip around the flange and into the gutter where it can be diverted away from the roof.

Is flashing and capping the same?

Counter-flashing: Placed opposite to base flashing, or above base flashing, counter-flashing completes the two-part team. Cap flashing: An L shaped structure that lies flat against the roof and other fittings such as windows. The shape of the structure runs water off in the opposite direction.

What is the difference between wall flashing and step flashing?

The base flashing (or apron flashing) is the bottom piece. Step flashing: Step flashing is a rectangular piece of flashing bent 90 degrees in the center. It is used for roof to wall flashing. Multiple pieces of the flashing will be installed in layers with shingles to ensure the water flows away from the wall.

How far below drip edge should gutters be installed?

MISTAKE #4 – Improperly Locating the Gutter When choosing gutters, consider the material, as well as the size and width needed. Your gutter needs to be a few inches under the edge of your roof.

Do I need a drip edge on rake edge?

It’s important to understand that drip edge installation is different for eaves and rakes. After your roof deck has been prepared, and before you install underlayment, you need to install drip edges at the eaves. You install drip edges on the rakes after you install the underlayment.