What does Error 3 mean on a king pellet stove?

E3 means the stove is shutting down because you are over the high temperature limit.

What does Error 2 mean on my king pellet stove?

Error code #2 according to your manual is: hopper empty, auger output failure or jam, flame of fuel quality caused fire to burn too slowly or go out, electrical open in low temperature switch or wiring.

What does Error 11 mean on a king pellet stove?

If your 5500 pellet stove’s digital display shows a flashing “A” and the glass door is completely shut, this indicates a vacuum issue. The code “ERR-11” signals a vacuum problem. Problems such as this, a faulty circuit board and other more complex mechanical troubles require service from authorized technicians.

What does E4 mean on a pellet stove?

E4 is a 12 Minute time out if there is no fire in 12 minutes. This could be a bad sensor. E3 error means the hopper ran out of pellets. This could also be a bad sensor. So I would check or replace the Low Limit Snap disc before replacing the circuit board.

What does E2 mean on a Vogelzang pellet stove?

E2 is lack of vacuum. Pull the hose off the vacumm switch(inside the back of the stove) and try to blow through the hose.

What does E2 mean on a Ashley pellet stove?

| The error codes are alphanumeric codes that appear on the control board and indicate a malfunction of the pellet stove. The E2 code indicates light leak, the E3 code is called overheating and indicates that the exhaust temperature has been exceeded, and the E4 code indicates a drop in the exhaust temperature.

What does E4 mean on my Ashley pellet stove?

E4 is a 12 Minute time out if there is no fire in 12 minutes. This could be a bad sensor. E3 error means the hopper ran out of pellets.

Why do I have to reset my pellet stove?

If your pellet stove is experiencing combustion issues, due either to lack of maintenance or other internal issues, it may shut down on its own. This means you’ll need to reset the stove by clearing the valves, flue and chambers to fix the combustion problem.

When does the king pellet stove need to be installed?

This manual describes the installation and operation of the King, KP130 pellet stove. This heater meets the 2020 U.S. Environmental Protection Agency’s crib wood emission limits for wood-heaters sold after May 15, 2020.

Why does my King pellet stove have soot in it?

The flyash will collect in the exhaust venting system and restrict the flow of the flue gases. Incomplete combustion, such as occurs during startup, shutdown, or incorrect operation of the room heater will lead to some soot formation which will collect in the exhaust venting system.

What does code err-11 mean on 5500 pellet stove?

Time to Call. If your 5500 pellet stove’s digital display shows a flashing “A” and the glass door is completely shut, this indicates a vacuum issue. The code “ERR-11” signals a vacuum problem. Problems such as this, a faulty circuit board and other more complex mechanical troubles require service from authorized technicians.

What are the emission limits for pellet stoves?

This heater meets the 2015 U.S. Environmental Protection Agency’s crib wood emission limits for wood heaters sold after May 15, 2015. Under specific test conditions this heater has been shown to deliver heat at rates ranging from 9,126 to 27,677 Btu/hr. • IMPORTANT: Read this entire manual before installing and operating this product.

https://www.youtube.com/watch?v=WSAPdOYHC3U