How much does it cost to replace brakes on a Hyundai Elantra?
How much does it cost to replace brakes on a Hyundai Elantra?
Hyundai Elantra brake pads replacement, which includes parts and labor, can cost anywhere between $150 and $300 per axle depending on the type of brake pads desired and the extent of the damage your previously worn down pads have caused to the other components of your vehicle such as the rotors.
How hard is it to change brake pads on Hyundai Elantra?
Replacing your Hyundai Elantra’s brakes is a relatively quick and simple job, even for amateur home mechanics. If you have all of the proper tools at your disposal, you should be able to replace all four sets of brakes in about an hour.
How much is a brake job at Hyundai?
How much does it cost for brake repairs or brake replacement? Brake repairs or brake replacements for your Hyundai depends on your model type and the type of repairs needed. Hyundai brake repairs and replacements currently start at $157.00 and go up to $399.00, and labor cost is $90.00 per hour.
How much does it cost to replace all of your brakes?
A complete brake repair — one that includes pads, rotor and caliper replacement — typically averages between $300 and $800. However, depending on the make and model of your vehicle, you can easily spend more than $1,000 on a complete brake job.
How do you replace brake pads on a Hyundai Elantra?
Try to pull the old brake pads out of the caliper mount by hand. If they’re stuck to the rotor, which is fairly common, use the screwdriver to pry them off and then remove them. Slide the new brake pads into the caliper mount in the same way the old ones were installed.
Where is the floor jack on a Hyundai Elantra?
Slide the floor jack under a solid part of the suspension on the front end of the car. Carefully jack the car up until it is high enough for you to be able to slide jack stands under the front axle.
How do you remove a brake caliper from a car?
Pull the jack stands out, then slowly lower the car back to the ground. Move the wheel chocks to the front of the front tires, then repeat steps three through 12 on the rear wheels of the car. Letting the brake caliper dangle by the brake line can damage it, making your car unsafe.