How many steps is a general energy control procedure?

Six Steps of LOTO Safety & Lockout/Tagout Procedures.

How many steps are in Loto?

Six Steps
Six Steps Of LOTO Safety & Lockout/Tagout Procedures.

What is an energy control plan?

The purpose of the energy control program is to ensure that, whenever the possibility of unexpected machine or equipment start-up exists or when the unexpected release of stored energy could occur and cause injury, the equipment is isolated from its energy source and rendered inoperative prior to servicing.

How many steps are in lockout tagout?

6 Steps
The 6 Steps of Lockout/Tagout. Without the use of proper Lockout/Tagout safety procedures, the equipment being worked on can unexpectedly start up or release these forms of energy.

What are the steps involved in energy control?

The steps involved are described in this roadmap below. It involves: Listing all sources of hazardous energy, with machine-specific information. Remember to assess the hazardous energy within a machine such as hydraulic pressure (tanks and lines) and compressed air.

What are the 7 steps of energy management?

Step 7 seeks the optimum source or sources for your overall energy requirement. This may include such considerations as heat recovery systems, alternative tariff structures, alternative fuels, or even larger measures such as a co-generation or combined heat and power (CHP) system. 7 Steps for Energy Management

What is the Energy Control Program ( ECP )?

Information about the Energy Control Program (ECP) is contained in 29 CFR 1910.147, Control of Hazardous Energy (Lockout/Tagout). The regulation addresses the practices and procedures necessary to disable machinery or equipment, thereby preventing the release of hazardous energy while employees perform servicing and maintenance activities.

What is the template for control of hazardous energy procedure?

Template For Control of Hazardous Energy Procedure (Lockout/Tagout) In accordance with Wisconsin Safety and Professional Services Chapter SPS 332 and OSHA 29 CFR 1910.147 Note: This document provides an over view of OSHA’s Control of Hazardous Energy standard along with a template for a basic written Lockout/Tagout procedure.