How do you install hardwired puck under cabinet lighting?

Then, follow these steps for installation:

1. Disconnect the power. Locate the correct breaker and turn off the power supply to the switch outlet where you’re going to connect the lights.
2. Attach the lights.
3. Cut the wall.
4. Run the wire.
5. Run the cord.
6. Connect the lights.
7. Wire the switch.
8. Cover your work.

How do you attach puck lights?

Just push the light into the hole you made for it. Use your screwdriver to attach the lights permanently into place. Puck lights plug into each other. You may put up to 10 puck lights on one strip.

How far apart should under cabinet puck lights be?

In general, one puck light is needed for every 8–12 in. of cabinet length. This spacing will provide the best uniformity and distribution of light and avoid any dark areas under the cabinets. Incandescent linear lighting comes in two forms: as a light strip or as a linear fixture or light bar.

Do LED puck lights need a transformer?

Many xenon and halogen puck lights operate on 120V AC directly, but others operate on 12V and will require a transformer to drop down the voltage. LEDs do not operate on AC line voltage, but rather low voltage DC, so they will require a power supply to convert the line voltage.

Why can’t under cabinet lights be on a dimmer?

You need to have the remote control handy to turn on the lights and to dim them. Hard wired under cabinet lights have more flexibility when it comes to dimming.

How do you decorate with puck lights?

7 Creative Uses for Puck Lights

1. Underneath Cabinets. The standard use for puck lights is underneath kitchen cabinets.
2. Highlight Decor on a Shelf.
3. Inside Kitchen Cabinets, Drawers, or the Pantry.
4. Create a Reading Nook.
5. Walkways and Outdoor Seating Areas.
6. Hallways.
7. In the Bathroom.
8. In Your Office.

What are LED puck lights used for?

Puck lights are a fantastic way to illuminate certain areas or provide accent lighting. These little lights provide easy access to soft lighting that won’t ruin your lighting atmosphere.

What’s the best way to install Puck lights?

Grab The Tools Once traced, take down your puck lights. Double-check the dimensions of your tracings with the recommended diameter and depth from the manufacturer. (Usually the depth is about 1/2in give or take). Then, use a hole saw to drill into the bottom of your cabinets or shelves. 6. Attach

How to install low voltage under cabinet lighting?

How To: INSTALL LOW-VOLTAGE UNDER-CABINET LIGHTING INSTALLING THE UNDER-CABINET LIGHTS 01 Remove the lens cover from the light housing. Some snap into place and others are screwed in. 02Hold the light in the marked position with the wire notch toward the back of the cabinet.

Where to buy hardwired Puck lights at Home Depot?

Hardwired – Puck Lights – Cabinet Lights – The Home Depot Get free shipping on qualified Hardwired Puck Lights or Buy Online Pick Up in Store today in the Lighting Department.

How does a corded Puck Light system work?

A corded puck light system plugs into a nearby outlet and can include a dimmer switch to control light intensity. Kits include an electronic transformer that reduces household voltage (120v) to power required by the lights (3v – 20v). The following instructions are for installation of a corded low-voltage puck lighting kit.