Useful tips

How do you bleed power trim and tilt Mercury?

How do you bleed power trim and tilt Mercury?

Bleeding: OB tilt/trim units are “self-bleeding” and you should always perform these “purge cycles” even if you don’t need to add any more fluid. To purge/check, remove the tilt lock (if engaged) and cycle the OB down by “jogging” it down, in 3 second bursts. Then rest the motor about 15 seconds.

How do you adjust the tilt on an outboard motor?

How to Adjust an Outboard Motor Angle for Best Performance

  1. Put the outboard in the “Trimmed In” position. This is the best position to start off with.
  2. Start the motor and monitor the performance of the boat.
  3. Adjust the motor from the “Trimmed In” position outward and see what happens to the performance of the boat.

Where is the tilt and trim limit switch on Mercury?

I have a 89 135 Black Max that at idle speed can trim prop out of water, but while riding only trims up half way. Can anyone tell me where the limit switch is on this motor and how to adjust it.

What is the tilt system on a MerCruiser?

Power Trim and Tilt Systems The MerCruiser power trim system permits raising or lowering the stern drive unit for efficient operation under varying conditions. Early stern drive units used a mechanical tilt system in the form of a series of holes in the gimbal ring.

Can a tilt engine hold up under power?

The tilt will not hold engine up under power, if prop is part of the way in water. You should be able to trim the engine to where pad is just touching the trim rams, apply power, trim rams should hold.

How to install a tilt and power trim system?

1. Remove 2 screws, lo&washers and retainers holding switch/sender to the gimbal ring. Remove the switch/sender. 2. Disconnect 2 wires from back of switch/sender 3. Reconnect wires to back of new switch/sender. Tighten screws securely and fill grooves with Anti-Corrosion Lubricant (part No. C-92-74048). Be sure screws are completely covered. 4.