How do I reset my Casio Exilim camera?

Turn on the camera, and then press the [MENU] button. Press the [/ dial right] button. Highlight “RESET” by use the [∨/ dial down] button.

How do you fix a lens error?

Blow compressed air in any gaps around the lens — or use a shop vac. Use a thin piece of paper or a needle to dislodge any visible bits of grit. Gently tap the camera in an attempt to realign jammed mechanics or dislodge particles (obvious warning: could cause further damage)

How do you fix a dropped camera lens?

Try pushing the lens barrel As the lens extend, usually the middle section rotates and in this situation, you can try to help it slightly. If this doesn’t help or the camera lens doesn’t extend, try to shake it up a little by knocking the front part of the device against your cupped hands as you turn it.

How do I fix my Nikon lens error?

Depending on which parts have been damaged the problem may be fixed by repairing and re-adjusting the lens unit or may require the replacing the whole lens unit, the cost of which might exceed the camera’s value. If the error continues to be displayed, contact your local Nikon Service Centre.

Why is my Casio Exilim lens not working?

I traced the problem to the battery. Apparently the Casio Exilim is more sensitive to power than other digital cameras. Fully charged batteries that work fine in other cameras, seem to give the Casio problems. I experienced these problems both on my Casio Exilim EX-S8 and my Casio Exilim EX-S5. Loading…

How to remove Phillips screws from Casio Exilim Z70?

Remove the two Phillips screws (2.83 mm) from the left side panel of the camera casing. The left panel can now be removed. However, one piece of tape attaches it to the camera, so a spudger may be required to ease the panels off.

Why does my Casio camera keep retrying power?

I would occasionally get lens errors or retry power on messages on my Casio Exilim digital camera. I traced the problem to the battery. Apparently the Casio Exilim is more sensitive to power than other digital cameras. Fully charged batteries that work fine in other cameras, seem to give the Casio problems.

Why does my camera say ” lens error “?

The camera powers on, and briefly shows an image on the LCD display. Then eventually it gives a “Lens Error” message. Has anybody gotten this error before? Know how to fix it, I’m thinking that since the camera shows an image on the LCD, it may be a software rather than hardware problem.