How do I get my viper out of valet mode?
How do I get my viper out of valet mode?
This method has you open the driver door, then press the lock button, immediately followed by the unlock button, immediately followed by the lock button again. The LED will illuminate solid to indicate the vehicle is in valet mode. To exit this mode, simply repeat the process.
What does Viper valet mode do?
What is Valet Mode? We all need to let other people operate our vehicle at some point or another. Whether it’s a valet at a restaurant or a mechanic at your local garage. With valet mode, you can disarm your alarm and hand the keys over without the worries of handing over your alarm system.
How do I reprogram my Viper 7145v?
What I did is:
- Open the door;
- Turn the key to ON;
- Within a short time, press and release the Valet/program button for exactly 7 times;
- Then press the Valet/program button one more, and hold it.
- While holding the Valet/program button, press the lock botton of the remote one time.
- Release the Valet/program button.
Where is the valet button on Viper remote?
What is the valet button on Viper remote? Enable Valet Mode It is a small, black, momentary button that is usually mounted in an accessible, but not obvious location towards the bottom of the driver’s side dash. A common location would be on the driver’s kick panel cover, or on the side of the center console (if the vehicle has one).
Do you need to Know Your Viper remote part number?
There are a lot of viper remotes in the market today. This is because viper has produced a lot of remote controls over the years that may seem similar, but they are different. So, if you are looking for the right viper replacement remote, you will need to know your remote’s RPN (Remote Part Number).
Where is the white stripe on the Viper remote?
It is a black wire with a white stripe and is located in the Viper remote start system. This may not be a typical case, but it can sometimes occur. To solve this, you will need to start by replacing the batteries with a new one and see if it works. If not, you can begin re-pairing your remote.
Where is the toggle switch on Viper remote start?
Toggle Switch in Off Position Viper remote start systems come with a toggle switch that gives you the ability to disable the remote start system at any time. If you had your remote start system professionally installed, the installer should have let you know where they mounted the switch.