How do I Access Cisco WAP4410N?

To configure the WAP4410N Access Point, follow these steps to access the WAP4410N web-based configuration utility from your computer. STEP 1 Connect the WAP4410N Access Point to the same network as your computer. STEP 2 Locate the IP address of the WAP4410N Access Point by accessing your DHCP server.

How do I reset my Cisco WAP4410N to factory settings?

To reset the Cisco WAP4410N to its default settings, you have to do the following steps:

1. Turn on router.
2. Press Factory Reset button and hold for at least 15 seconds.
3. Device restarts automatically.
4. Default settings have been restored.

How do I find the IP address of my Cisco access point?

To find the Access Point’s IP address

1. Open utility window, make sure Get IP addr is selected in the Function box.
2. Type the Access Point’s MAC address in the Device MAC ID field.
3. Click Get IP Address.
4. Write down the Access Point’s IP address that appears in the IP Address field.

How do I log into my access point?

Open the web browser and type the IP address of the access point/extender (Default is 192.168. 1.1/192.168. 1.254/192.168. 0.254) into the address bar and then Press Enter.

How do I reset my access point password?

Resetting the access point using the Reset button Press and hold the Reset button of your access point for 30 seconds. Once the access point is reset, perform a powercycle. Unplug the access point’s power cable and wait for 30 seconds then plug it back in. Wait for the access point’s lights to appear solid.

How do I reboot my access point?

To restart an AP, expand the Access Points section, click the AP’s box on the left side, then click Restart.

How do I reset my engenius access point?

To reset your device to its default settings ensure that the device is powered up then press and hold the recessed reset button for 10 seconds then release. The button is located to the left of the LAN port on the back panel of the device and will require a thin object such as a paperclip to access it.

How do I access my wireless access point?

What’s the default IP address for wap4410n access point?

You may need to disconnect and reconnect the devices for them to discover their new IP addresses from the DHCP server. If the WAP4410N access point does not receive a DHCP response after 60 seconds, it falls back to the following default static IP address: 192.168.1.245 and a default mask of 255.255.255.0.

What does the Cisco wap4410n power over Ethernet do?

It also supports the Wi-Fi Protected Setup (WPS) feature to help you simplify the setting up of security on a wireless network. The Cisco WAP4410N offers the convenience of Power over Ethernet (PoE), in addition to regular 12VDC power adaptor, so it can receive data and power over a single Ethernet network cable.

Where can I find the wap4410n subnet mask?

I suspect that when you are typing 10.1.XX.XX you are reaching the router or another device. The easiest way to ensure you are reaching the WAP4410N is to plug it directly into a PC that has a static IP address such as 192.168.1

How long does it take to reset a WAP 4410 N?

When you hold down the reset button, try holding it for greater thn 30 secs. When doing a factory reset on any of our devices, I will usually hold that button down for about 35 to 45 seconds. This should reset your device back to factory settings.

https://www.youtube.com/watch?v=quaF-FQIlWs