Can you add factory trailer brake controller Silverado?

Expert Reply: You can absolutely install an aftermarket trailer brake controller to your 2021 Chevy Silverado 1500 with the factory tow package, so whoever told you that had some bad info. And since you have the factory tow package you can simply add a plug and play brake controller for a simple install.

Can you install a brake controller yourself?

Installing a brake controller involves disconnecting the vehicle battery, mounting the brake controller onto dash and plugging the unit in with a vehicle-specific wiring harness. If your vehicle is not equipped with a plug-and-play harness, you can also splice in wiring for connecting a brake controller.

Where does brake controller go on Silverado?

Factory Brake Controller Port Location on 2018 Chevy Silverado 1500 The factory brake controller port on your 2018 Chevy Silverado 1500 is in your vehicle’s junction box underneath the dash, to the left of the steering column, just above the carpeting.

How much does it cost to install a brake controller?

What is the average cost to install brake controller? On average, you can expect to pay between $60.00 and $340 for the controller itself and up to $300 for labor on the most complicated installations.

How do you remove a trailer brake controller?

The easiest way to temporarily disconnect power to the trailer brakes is to disconnect your brake controller. Unplug the brake controller plug from the back of the brake controller. The trailer brakes cannot draw power from the vehicle’s battery if the brake controller is not plugged in.

Can I tow a trailer with electric brakes without a brake controller?

The answer is, no. Electric trailer brakes do not work without a brake controller. If your trailer is equipped with electric brakes, you will need a brake controller to tow. These are a hydraulic braking system that uses the trailer’s own weight and momentum to actuate the brakes.

What should my trailer gain be set at?

How to Set the Gain on a Trailer Brake

• Move the gain control to the 50 percent mark or the center position on the slider.
• Test the setting by towing the trailer on a level, dry, paved road at approximately 20 mph.
• Push the manual override button.
• If the trailer brakes do not grip firmly, increase the gain.

Does my 2013 Silverado have trailer brakes?

This article applies to the Chevrolet Silverado 1500 (2007-2013). Unfortunately, GM chose not to make trailer brake controllers standard with the HD towing option.

Where is the trailer brake controller on a Silverado?

Looking under the driver side dash on the left side, you’ll see a wiring harness taped up out of the way. This is the trailer brake harness that you’ll need to pull down. Figure 1. Trailer brake controller harness. Once you have the trailer brake wiring to your trailer brake controller wiring mapped out, you can start making the connections.

What’s the best way to install a brake controller?

Just 5 Steps to Install Brake Controller and Wiring! Installing a brake controller involves disconnecting the vehicle battery, mounting the brake controller onto dash and plugging the unit in with a vehicle-specific wiring harness.

How to install a brake on a Chevy Silverado?

To make the connections you can use butt connectors and then crimp the wires in place or you can solder them together if you wish. Once you have finished making the connections, it’s recommended wrapping them in black electrical tape to both help keep the connections tight and secure and also to help tidy them up.

Do you need a brake controller for a 2013 Chevy truck?

2013 should be the same way, so long as you have the factory 7-pole connector at the rear of the truck. If you do not have the factory 7-pole, you will also need part PK11916. 487