Why am I getting a reorder tone?

Reorder tone This can occur either because the Inter-LATA trunk is busy at the time of the call- in which case this clears in a few seconds, if one redials- or the number is temporarily out of service, due to maintenance or the number is not willing to accept calls.

What is reorder tone on Panasonic phone?

The reorder tone, also known as the fast busy tone, or the congestion tone, or all trunks busy (ATB) tone is an audible call progress tone in the public switched telephone network (PSTN) that is returned to a calling party to indicate that the call cannot be processed through the network.

What does a reorder tone sound like?

A busy tone (Busy Signal) and a reorder tone are two similar on-off repeating tones that differ in the spped that they beep on and off. Some lay terms for a reorder tone is a Fast Busy tone. Both types of tones use two different frequency tones simultaneously, 480 and 620 Hz, for the beep sound.

Why am I getting a busy signal on a cell phone?

If you get a busy signal or fast busy signal before your call is dropped, it’s possible your number is blocked through their wireless carrier. To verify, call someone else — particularly if they have the same carrier as the person you’re trying to reach — and see if the call goes through.

Is there way to speed up echo canceller in asterisk?

The echo canceller in Asterisk requires some time to learn the echo, but you can speed this up by enabling echo training (echotraining=yes). This tells Asterisk to send a tone down the line at the start of a call to measure the echo, and therefore learn it more quickly.

Who is the free PBX download for Asterisk?

With the FreePBX download, application developers and integrators can concentrate on building solutions, not maintaining the plumbing. Who is FreePBX for? FreePBX was built for application developers, systems integrators, students, hackers and others who want to create custom solutions with Asterisk.

Which is the best signaling protocol for Asterisk?

All home lines (and analog telephones/modems/faxes) in North America use loop-start signaling. Kewlstartis in fact the same as loop start, except that it has greater intelligence and is thus better able to detect far-end disconnects.[54] Kewlstart isthe preferred signaling protocol for analog circuits in Asterisk.

How to tell asterisk about a hardware feature?

You tell Asterisk about the hardware and control the associated features via zapata.conf: