What tools are needed to change injectors?

Tools And Equipment Needed:

1. Replacement fuel injectors.
2. Fuel injection test light kit.
3. Fuel injection test set.
4. Multimeter / Ohmmeter.
5. Needle nose pliers or flathead screwdriver.
6. Safety goggles.

What tools do I need to remove fuel injectors?

Here is a list of tools you will need to get this job done:

• Eye protection (safety glasses or goggles)
• Nitrile exam gloves.
• Flathead screwdriver – removal of plug harness clasp.
• Ratchet set or Phillips screwdriver – removal of fuel rail.

How Long Will CAT 3126 last?

typically a Cat block will last 500,000miles or more before the block is worn out. School buses are typically well maintained and in good shape and they age out before they mile out. if your really worried you can take it to a cat dealer and they can give it a inspection and let you know but that would be a bit pricey.

What is injector cut out test?

A cut-out test will identify weak cylinders, which is not always bad injectors. In my experience if a cylinder or two show weak at idle, but improves at 1000 RPM, it’s an indication of a poor spray pattern on the injector. As far as trim codes, YES, change them to what the injectors say.

How do I know if my injector is bad on my Cummins?

Cummins recommends a simple visual test to start. First remove the valve cover, then crank the engine and let it idle. With a light, study the injector body of each cylinder. Sometimes, if the injector body is cracked externally, you may be able to notice a small wisp of smoke from the injector.

How do you change the injector on a 3126 cat engine?

1. Remove oil drain plugs (1) at each end of the cylinder head. 2. Allow the engine oil to drain from the ports in the cylinder head before the injector is removed. 3. Disconnect harness connector (2) . Note: Some of these engines were built without the deflector.

How does the injector cup sleeve puller and driver work?

Save yourself or your company time and money with our Cat C7 / Cat 3126 Injector Cup/Sleeve Puller and Driver set. The injector sleeve/cup puller threads into the old cups to remove them from the bore of the engine. The driver then sets the new cups into the bore where your previous cups were, reducing your labor time considerably.

Which is front wear sleeve installer for Caterpillar C-10 engines?

M10235 Front Wear Sleeve Installer For Caterpillar 3176, 3196, C-10, C-12 Engines 145-5247 M10236 Rear Wear Sleeve Installer-Caterpillar 3176, 3196, C-10 and C-12 Engines 147-2675 J-42083 Caterpillar Automatic Timing Pin 3200, 3300, 3406, 3408, C-7 ,C-9, C-15, C-16, 3179, 3196 13 Your shopping basket is currently empty.

What is the timing pin on a caterpillar?

J-42083 Caterpillar Automatic Timing Pin 3200, 3300, 3406, 3408, C-7 ,C-9, C-15, C-16, 3179, 3196 13 Your shopping basket is currently empty.