What is the OSHA standard for hot work?
What is the OSHA standard for hot work?
OSHA defines hot work to include riveting, welding, flame cutting, or similar fire- or spark- producing operations. Requirements for hot work are in 29 CFR 1917.152.
What are the OSHA requirements for welders?
Railing or other suitable fall protection must be provided as required. Welding cable and other equipment must be kept clear of passageways, ladders and stairways. Eye protection and protective equipment of specific appropriate types must be worn. Nearby workers must be protected from arc welding rays.
When combustible material Cannot be kept at least 35 feet away from a welding area A is required?
1910.252(a)(2)(vii) Relocation of combustibles. Where practicable, all combustibles shall be relocated at least 35 feet (10.7 m) from the work site.
When welding or burning within 35 feet of any combustible material A is required?
Flammable, combustible, or ignitable materials should be kept a minimum of 20 to 35 feet away from the hot work, or those materials should be covered with a flame-retardant covering for protection. Have a permit signed to show that all phases of the work have been inspected and approved.
Where can I find OSHA standards for 1910?
Refer to 1910.155 (c) (3) for definitions of listed and approved, and 1910.7 for nationally recognized testing laboratory.
What are the requirements for fire protection in 1910?
1910.252 – General requirements. General requirements. Fire prevention and protection. Basic precautions.
What are the OSHA standards for welding, cutting and brazing?
OSHA’s standards for welding, cutting and brazing in general industry and construction were based on the 1967 ANSI standard Z49.1. Welding, cutting and brazing are hazardous activities that pose a unique combination of both safety and health risks to more than 500,000 workers in a wide variety of industries.
What was the arc welding and Cutting Act of 1910?
1910.254 – Arc welding and cutting. Arc welding and cutting. Equipment selection. Welding equipment shall be chosen for safe application to the work to be done as specified in paragraph (b) of this section. Installation. Welding equipment shall be installed safely as specified by paragraph (c) of this section.