What causes P0170 code?

Error Code P0170 is set when the PCM has detected an anomaly on fuel (fuel trim) that is outside the range of the vehicle’s specifications. This can be a negative or positive trim. This code means there’s a malfunction in the computer’s control of air to fuel ratio.

What is fuel trim Bank 2?

Error Code P0173 is described as Fuel Trim Malfunction Bank 2. This means the PCM (powertrain control module, also known as ECM or engine control module) has detected a fuel trim outside the specified range set by the vehicle’s manufacturer. This can be a negative or a positive fuel trim.

What is fuel trim bank1?

Diagnostic Trouble Code (DTC) P0170 stands for “Fuel Trim Malfunction (Bank 1).” Fuel trim is the adjustment made by the PCM to the engine’s air-fuel mixture. The P0170 code indicates that the fuel trims have reached an abnormally low or abnormally high value for a specified amount of time.

Can you drive with a p0170 code?

You can continue to drive the car with this code. The code is basically for a rich fuel mixture. This can mean you may see some loss of fuel mileage, however the car should get you to your destination.

Can I drive with a p0170 code?

How do you fix code P0171?

What repairs can fix the P0171 code?

1. Replacing the fuel pump.
2. Replacing the fuel filter.
3. Replacing the fuel pressure regulator.
4. Replacing the powertrain control module.
5. Replacing one or more injectors.
6. Replacing one or more oxygen sensors.
7. Replacing the mass air flow sensor.
8. Repairing a vacuum leak.

How long does it take for long term fuel trim to adjust?

five to 20 seconds
In general, it takes anywhere from five to 20 seconds for LTFT to change, and since it’s stored in memory when the engine is switched off, that same LTFT value is used next time the system goes into closed-loop operation.

What is a good long term fuel trim reading?

Ideally, long-term fuel trims should be at, or close to 0% when the engine is running at a steady speed. Nonetheless, as a rule of thumb, long-term fuel trim values that hover around the 5 to 8 percent mark – either negative or positive- are not necessarily indicative of a problem.

How long does it take for long-term fuel trim to adjust?

What causes a Mercedes Benz to have a p0170 code?

P0170 and P0173 Code Causes The most common cause of P0170 and P0173 on a Mercedes-Benz is a defective mass-airflow sensor. The MAF sensor gets dirty over time triggering the CEL and the two codes.

What does it mean when your fuel trim code is p0170?

In writing this article I’ve added Mercedes-Benz-specific info since it seems that M-B (and VW) are most prone to having this P0170 surface along with misfire codes or other fuel trim codes. P0170 means there was a malfunction in the computer’s control of the air:fuel ratio.

How much does it cost to diagnose a p0170 code?

The cost to diagnose the P0170 code is 1.0 hour of labor. The auto repair’s diagnosis time and labor rates vary by location, vehicle’s make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour. How much do you know about cars? When is the code detected?

What are the symptoms of a p0170 DTC?

Symptoms of a P0170 DTC may include: Potential causes include a vacuum leak, unmetered air leaks Fuel saturated engine oil Leak in turbo air charge hoses (if equipped) Possibly bad O2 sensor (If Mercedes, may require adaptation with M-Benz compatible scan tool.) Oil contamination in MAF connector or O2 sensor connectors.