How much does Ford charge for a coolant flush?

How do you flush the coolant on a Ford Taurus?

Instructions for a Ford Taurus Radiator Flush

1. Drive the front of the Ford Taurus onto a set of car ramps and secure the parking brakes.
2. Open the engine hood of the Taurus and remove the radiator cap.
3. Place a three- to five-gallon drainage pan under the drain spout of the radiator.
4. Open the drain spot with your fingers.

Is a coolant flush necessary?

If you find that your temperature gauge is always high and your engine is frequently overheating, chances are that you need a coolant flush. Allowing your engine to overheat can cause serious, costly problems, so it is best to visit a mechanic at the first signs of temperature issues.

Can a coolant flush damage your engine?

Getting a coolant flush will prevent the old anti-freeze from becoming acidic. This is important because once it starts to become acidic it will break down and can damage the bearing in the water pump, the rubber hoses and the aluminum components of the engine.

Can I do a coolant flush myself?

Flush the Radiator Remove the radiator cap and pour distilled water into the radiator until full. Replace the cap, then start up the vehicle and let it run for 10 to 15 minutes. This will work the distilled water into the engine, flushing out any loose debris or corrosion along with the last of the old antifreeze.

What coolant does Ford use?

Motorcraft® antifreeze/coolants
Ford Engineers for Ford, Lincoln and Mercury Vehicles Motorcraft® antifreeze/coolants meet specific Ford Motor Company engineering standards.

What is coolant reservoir?

The coolant reservoir is the plastic reservoir mounted in the engine bay that stores the coolant for the engine. Coolant reservoirs are required because engines go through cycles of expelling and absorbing coolant as they warm up and cool down.

What kind of antifreeze does a 2002 Ford Taurus take?

The 2002 Ford Taurus most recommended coolant is Prestone, yellow 50/50 pre-diluted coolant or antifreeze.

What happens if you don’t flush your coolant?

If you use only water without coolant, your hoses and pipes will eventually rust, leading to bigger problems like leaks or system malfunction. Coolant, also known as anti-freeze, protects your cooling system while aiding the water in absorbing heat from the engine.

Is a radiator flush the same as a coolant flush?

A coolant flush is another name for radiator flush, a procedure to clean your vehicle’s cooling system of sediment and rust. The coolant keeps your engine from overheating while running, and from freezing in cold weather when it’s not running.

When should I do a coolant flush?

If you are wondering about your car’s cooling system maintenance interval, you can refer to your owner’s manual to find out what the manufacturer recommends. In general, most vehicles require coolant service every 30,000 miles or 5 years, whichever comes first.

Can you flush coolant with tap water?

You can use tap water, no problem. I recommend flushing the system as best you can with the hose, by pulling the right bottom hose off. Flush out as best as you can. Put the hose back on and fill the radiator.