How does a Carling switch work?

A rocker switch is a type of switch that breaks and connects the electrical circuit by “rocking” in one direction to break the circuit, and the other direction to connect the circuit. When a rocker switch is switched in the “on” direction, it pushes the contacts into a “closed” position.

What is a on off on switch?

The ON-OFF-(ON) circuit is a momentary, double throw, three-position switch circuit. In general, for basic unlighted single pole switches, the maintained ON position closes the circuit at switch terminals 2 & 3, and the momentary ON position closes the circuit at switch terminals 1 & 2.

How does a on on switch work?

When a device sends a packet to another device, it enters the switch and the switch reads its header to determine what to do with it. It matches the destination address or addresses and sends the packet out through the appropriate ports that leads to the destination devices.

What does 1 2 3 mean on a toggle switch?

It makes one of two connections. Here is a diagram of a SPDT toggle switch. Terminal 1 is connected to one load or accessory, Terminal 3 is connected to another load or accessory. Terminal 2 is connected to power. The switch is always making one of the two connections and flips between them.

Is the line on a switch on or off?

IEC 60417-5007, the power-on symbol (line), appearing on a button or one end of a toggle switch indicates that the control places the equipment into a fully powered state. IEC 60417-5008, the power-off symbol (circle) on a button or toggle, indicates that using the control will disconnect power to the device.

Can a Carling vjd1 be replaced with a v6da?

It has one dependent lamp at the top, and one at the bottom. If you’re replacing an existing rocker switch, it will likely have “VJD1” stamped on the side, but will also replace a V6D1, a VJDA and a V6DA. This switch will light the bottom light when it is down, and the upper light when it is up.

What are the different types of Carling switches?

Carling miniature and subminiature sealed & and non-sealed switches come in 1-4 pole configurations from 0.10A to 6 amps. The miniature and subminiature switch lines include rocker, paddle, toggle, push button, and slide switches with PC, PCB, snap-in, & surface mount options.

How does a Carling marine rocker switch work?

This switch will light the bottom light when it is down, and the upper light when it is up. This is a rocker switch body only. This rocker switch body is meant to be paired a etched or printed rocker switch cover for a complete switch unit.

When to use vjd2 or vjjd1 on a rocker switch?

You would most often use the VJd2 instead of the VJD1 when this switch will be triggering two loads, but NOT the backlights in a bank of backlit rocker switches.