How do I telnet to a Cisco access point?
How do I telnet to a Cisco access point?
a) From your computer, open a telnet session. For example, in Microsoft Windows select Start > Run and in the text box type Telnet and press Enter. b) When the Telnet window appears, click Connect and select Remote System. In the Host Name field, enter the access point’s IP address and click Connect.
How do I view Cisco AP logs?
To view message logs using the controller GUI, choose Management > Logs > Message Logs. The Message Logs page appears.
How do I enable telnet on WLC?
To enable Telnet control from WLC web interface
- Open the WLC web GUI.
- Click Configure > System > Security.
- Select the “Enable telnet” check box.
- Click Apply to save the changes.
- After the Telnet option is enabled, WLC can be accessed via Telnet by using any one of the terminal emulators such as Putty/SecureCRT.
How do I connect to Cisco AP?
In order to access the AP with the GUI and open the Summary Status window, complete these steps:
- Open a web browser, and enter the IP address of the AP in the address line.
- Enter the Username and Password. The default username and password are Cisco.
How to log into Cisco Aironet through the GUI?
If the access point does not have a console port, use either the GUI or the Telnet for access. For information on logging into the AP through the GUI, refer to Using the Web-Browser Interface for the First Time. For information on logging into the AP through the CLI refer to Accessing the CLI.
How to reset Cisco Aironet to factory settings?
Follow these steps to reset the access point to factory default settings using the access point MODE button: Step 1 Disconnect power (the power jack for external power or the Ethernet cable for in-line power) from the access point. Step 2 Press and hold the MODE button while you reconnect power to the access point.
How to telnet into an access point-Cisco community?
a) From your computer, open a telnet session. For example, in Microsoft Windows select Start > Run and in the text box type Telnet and press Enter. b) When the Telnet window appears, click Connect and select Remote System . In the Host Name field, enter the access point’s IP address and click Connect. Note: In…
How to access the command line on an Aironet AP?
Refer to Cisco Technical Tips Conventions for more information on document conventions. You can use any of these methods in order to access the command-line interface (CLI) on the Aironet AP: