How do I setup my uverse wireless receiver?

Press the OK button on the front of the wireless TV receiver. Wait two minutes for the receiver and WAP to pair. After two minutes, the Link light on the front of the wireless TV receiver should be solid green. Following a successful pairing, unplug the wireless TV receiver and reconnect it at the desired location.

How does U-verse wireless receiver work?

The AT U-verse TV Wireless Receiver takes the video-streaming concept popularized by Roku and Apple TV devices and applies it to the venerable (well, infamous) cable box. AT’s residential gateway plugs into a phone outlet, and its wireless access point connects to the gateway.

How do I fix my AT wireless receiver?

Many receiver problems can be fixed by restarting your receiver. To do this, press and hold the Power button for 10 seconds. This takes 5-8 minutes and will impact any DVR recordings in progress. If you have multiple receivers, reboot your wireless gateway by unplugging it from its power source.

How many ATT U-verse wireless receivers can I have?

You can add up to two additional wireless receivers (for three total) to your home. These wireless receivers have a $49 one-time fee attached to each of them, in addition to the monthly fee.

How do I connect uverse to my new TV?

Plug your AT U-verse receiver into the wall to give it power. Turn on your TV. Using your TV’s remote control (not your AT U-verse TV remote control), select INPUT, TV/Video, or SOURCE to change your TV to the corresponding input. If necessary, refer to your TV’s manual to change the input.

Why is my U-verse TV not working?

Why does my U-verse keep saying restart receiver?

Try unplugging your receiver and waiting two minutes, plugging it back in, and then restarting. If that doesn’t solve the problem, unplug your Wi-Fi gateway and wait two minutes, then plug it back in and restart. This will temporarily disrupt internet, TV, and Voice service.

Why do I keep losing my U-verse signal?

Check the connections on the rear of the U-Verse receiver and your TV. Loose connections can disrupt service and freeze the image on the TV. Check the coaxial connection to the TV IN jack on the rear of the receiver as well as the audio visual connection between the TV and the receiver.

How many tvs can you watch with ATT Uverse?

U-verse TV can deliver a maximum of four simultaneous streams.

Does AT U-verse have wireless cable boxes?

AT U-verse now offering wireless set-top boxes.

How do I connect my AT U-verse to Ethernet?

Simply connect an Ethernet cable from the Ethernet port on your computer to any available Ethernet port on the back of your gateway. Ethernet ports are the yellow ports found on the back of your AT gateway. Your gateway may vary from the image shown.