How do I fix code P0880?
How do I fix code P0880?
What Repairs Will Fix P0880?
- Repair or replace damaged wiring/connectors.
- Replace the power relay.
- Replace the blown fuse(s)
- Replace the fusible link.
What is a TCM power input signal?
The transmission control module power input signal tells the ECU that the TCM is able to power up. If there is a low voltage signal on this circuit, not only will the TCM not be able to function properly, a P0882 DTC will be set. Need a replacement transmission?
What is TCM power input low?
P0882
The P0882 code (TCM Power Input Low) sets when the PCM sees less than three volts on the PCM output wires: pins 19, 28, and 38 on the C4 connector. There are four main reasons for this code to set: Bad connections and wiring on the transmission control or transmission output control wires.
What does it mean when your car has a code p0880?
If your vehicle has stored a code P0880, accompanied by a malfunction indicator lamp (MIL) and/or a TCM (transmission control module) lamp, it means that the powertrain control module (PCM) has detected a problem within the TCM power input circuit.
How to troubleshoot p0880 Transmission Control Module ( TCM )?
How do you troubleshoot code P0880? A diagnostic scanner, a digital volt/ohmmeter (DVOM), and a vehicle information source are some of the tools that will be required to successfully diagnose a P0880. A good starting point in your diagnosis is checking all system fuses and fusible links. This can be done using the DVOM on the voltage setting.
Why does the edge Evo pull the p0880 code?
When i got back home, i checked for DTCs’ and the edge evo still pulls the P0880 and wont erase the code out of itself, but no cel in the dash? Should i assume the truck is ok since the cel is not on? Would the TCM hold the code for a while for some reason or could it just be the programmer?
Is the p0880 still in P, D, N?
The factory guages seem to be fine now and while still, it will now go into P,D,N with the outline around the gear. Still no cel but the Evolution will repeatedly pull the P0880 even after eraseing. I left the batteries disconnected all day and im about to hook them up and drive it to see if it limps or whatever again. Thanks for the reply.