Where does the lock washer go on a hitch ball?
Where does the lock washer go on a hitch ball?
Place the lock washer and the nut onto the bottom of the shaft, and then move them up all the way so that they touch the ball mount. Now, screw the nut on very tightly, and keep the ball on top from moving around too much.
How do you secure a hitch ball?
Three easy steps to install a ball mount:
- Slide the ball mount into the trailer hitch.
- Insert the hitch pin through the hole in the receiver and ball mount.
- Secure the hitch pin by inserting the straight leg of the clip in the hitch pin.
How do you torque a hitch ball?
Curt recommends the use of 250 ft/lbs of torque when tightening the nuts of their hitch balls with a 1 inch diameter shank like the part # C40034 that you referenced. The general rule is for a 3/4″ shank tighten to 150 ft/lbs For a 1″ shank tighten to 250 ft/lbs, and for a 1-1/4 inch shank 450 ft/lbs.
How do I get my hitch ball unstuck?
Recommendation for Removing Stuck Ball Mount from Receiver The best way to remove a ball mount that is stuck in the hitch receiver is to spray it liberally with WD-40 or PB Blaster, let it sit for awhile, and then alternate hitting it in various directions with a rubber mallet.
What is the last part assembled on a hitch ball?
In order for the hitch ball to be secured properly, the last part which is assembled is nut. One should keep in mind that hitch ball and coupler for towing the boat must be of the same size.
How tight should a tow ball be?
A little bit of play is acceptable, the coupler should be tight enough that the coupler won’t come off the ball, but not so tight you can’t close the latch.
How do you torque a hitch ball to 450 ft-lbs?
450 ft/lbs = 150 pounds force applied at 3′. Turn the hitch 90 degrees in the receiver so you can stand on the pipe.
Can you flip ball mount?
Can You Flip a Ball Mount? Many trailer hitch ball mounts are designed to be flipped in the receiver tube to allow for necessary rise. Rise is the opposite of drop. It is needed when a trailer rides higher than the tow vehicle.