What size is the drain plug on transmission pan?

Transmission Drain Plug | 090-078 | Oil Drain Plug Transmission M10-1.50, Head Size 14mm | Dorman Products.

How do you check the transmission fluid on a Saab 9 5?

Run the engine at idling speed, engage position D and wait at least 15 seconds. Then engage R and wait 15 seconds. Do the same in position P. Wipe the dipstick clean with a lint-free cloth and put it back in the gearbox.

Can I reuse transmission drain plug?

Just clean the threads and reuse them. Some of the plugs are plastic and if you need to apply a lot of torque to remove them or put them back on, the socket can get rounded out a bit. You can re-use them, but be sure they are in good condition, or you will regret this the next time you go to change the fluid.

Do you drain transmission fluid hot or cold?

Fluid changes should only be done when the engine and transmission are at normal operating temperatures. With your vehicle raised, let the engine idle for a few minutes, then turn it off. When the transmission fluid is still warm, but the vehicle has cooled down, you’re ready to remove the old transmission fluid.

How do you fully drain transmission fluid?

The trick on how to drain transmission fluid is to work from the top, sucking out the old fluid up through the filler tube. Then refill with fresh fluid. A hand-operated vacuum transmission fluid pump makes the job simple and clean. You can remove one-third to one-half of the fluid from the transmission at a time.

How do you remove transmission fluid without dropping the pan?

How to Change Transmission Fluid Without Removing the Pan

1. Start and run the engine.
2. Park and secure the vehicle.
3. Place the bucket under the transmission drain pan.
4. Carefully remove the drain plug using a socket wrench with the appropriate socket.
5. Replace the crush washer.
6. Replace the drain plug.

Is there a drain plug on a transmission?

If it is a manual transmission, it will typically have a large drain plug on the bottom of the transmission housing. If it is an automatic transmission, it will either have a large drain plug on the housing, a drain plug on the transmission pan, or the transmission pan will need to be removed.

Do you need to replace crush washer when changing oil?

yes because it crushes to make a tight seal with the drain plug bolt. If you don’t replace it you might not have a tight seal and end up leaking a little oil.

Are transmission filters reusable?

Senior member. My understanding is that transmission filters are replacable, not reusable. Since transmission fluid is replaced every ~60,000 miles I wouldn’t want a filter which isn’t new and without particles in the filter media, ya know? It’s like asking for trouble down the road.

How do you change transmission fluid in a Saab 9-5?

Use the new washer after the final drain. About 4 quarts/liters is drained every time so fill up the transmission with 4 quarts/liters of new ATF. The fluid is added through the dipstick tube. Warm up the engine. Shift through Drive and Neutral so the fluid can get distributed through the transmission.

Where is the drain bolt on a Saab 9-5?

The drain bolt is located to the right of the exhaust when looking from the front of the car. It’s the only 24mm bolt in that area so you can’t mistake it for anything else. There is not enough room for a socket so an open-ended or ring wrench/spanner is needed.

What happens when you change the ATF in a Saab?

The ATF will start draining out slowly when the bolt is almost at its end. Removing the bolt will make the fluid gush out because it’s a pretty large opening. Because the engine is warm/hot, this fluid can be very hot so be very careful not to get it all over your hands or arms. It really can cause severe burns.

How many miles should I use on my Saab 9-5?

While they advice 100K miles for MY03, it’s safe to assume 60,000 miles should be used for all model years MY02 and up. This is very easy to do yourself. If you can hold a wrench, loosen/fasten a bolt and pour liquid from a bottle, you can do this!