What is burndy Insulink used for?

Pre-insulated service entrance compression connector installed with OH25, OUR840 and MD6 HYTOOL™ as well as Y35 and Y750 HYPRESS™ tools. Polyethylene caps prevent dirt from accumulating in barrel, grip cable for easy two-hand installation, and seal out moisture.

What is a Insulink?

INSULINK™ SERVICE ENTRANCE SLEEVE FOR INSULATED COMBINATIONS OF COPPER, ALUMINUM, ACSR COMPRESSED. Pre-insulated service entrance compression connector installed with OH25, OUR840 and MD6 HYTOOL as well as Y35 and Y750 HYPRESS™ tools.

How are aluminum conductors terminated?

Use a suitable stripping tool to avoid damaging the conductor and remove the required length of insulation. Wire brush the conductor and apply a listed joint compound. Tighten the connection per the manufacturer’s recommendation. Wipe off excess joint compound.

What does burndy make?

WHAT WE DO. BURNDY® today is a global organization known for their pioneering work in the manufacture of connectors, fittings, and tools for electrical utilities, commercial, industrial, and residential contractors, maintenance and repair companies, as well as the telecommunication and renewable energies market.

What can I use if I don’t have a crimping tool?

You don’t need a fancy tool, crimps are very soft, you can use pliers.

How do you terminate a conductor?

Contact the manufacturer or dealer and request the proper terminals, bolts, washers, and nuts. Order a terminal device that crimps on the end of the conductor and terminates on the terminal. Install a short lead wire on the terminal and splice it to the circuit conductors.

What is the difference between SEU and SER cables?

Basically, SER is a round service electrical cable that typically has up to four conductors and a bare neutral. SEU is an unarmored Style U flat service electrical cable with two-phase conductors and a concentric neutral.

What do you need to know about Burndy connectors?

A : Burndy Engineers our Connectors, Tools and Dies to all work together as part of The Burndy Engineered System. This includes design, testing and manufacturing of the Connectors, Tools and Dies which allows us to warranty these connections and meet the requirements of standards such as UL, CSA, IEEE, ANSI and others.

Is the Burndy unitap rated for motor connections?

A : Typically, Anything made out of copper is UL listed for copper conductors only. However, Burndy does offer a variety of aluminum connectors that are dual rated for both Copper and Aluminum. Q: Are the Burndy UNITAP™ connectors rated for motor connections?

What is the die index number on a hylink splice?

Most aluminum and copper HYLUG™ terminals and HYLINK™ splices are marked with a die index number and are color-coded to identify the correct installation die. Dies marked with the matching die index number and color can be used to install the connector.

Do you need a heat gun for Burndy clear Cold shrink tubing?

BURNDY Clear Cold Shrink Tubing. No heat gun or installation tool necessary. of innovation, testing and support. Behind every embossment is over 90 years of innovation, testing and support. T3 Technology with Onboard GPS. T3 Technology with Onboard GPS. BURNDY Digital Catalog is Active!