Is bee r rev limiter bad?

The Bee-R rev limiter works by cutting the ignition upon hitting the rev limit. This is prefered over fuel cut because, according to the site: Fuel cut, as used on many standard vehicles, risks damage to high performance engines when at high revs.

What is a bee r rev limiter?

The BEE*R rev-limiter allows fuel to pass into the engine still, limiting engine speed by disabling the ignition signal. The Bee*R rev limiter is fully adjustable in 500rpm increments, for safety reasons allowing only a lower rev-limit to be configured than standard.

How does a 2 step rev limiter work?

Essentially two-step works as a secondary rev limiter. Two-step works off of your speed sensor so it knows when you’re moving and when you’re not. When you’re not moving and the clutch is depressed, the motor will be able to rev and hold at a lower set value.

Is there a fitting guide for the Bee are rev limiter?

There is a fitting guide available for the Bee-R rev limiters on the Bee-R website, but it’s all in Japanese which poses a problem for the non Japanese fluent amongst us. This is the instuctions in japanese please use it to work out the correct wiring plug arrangement for your car. Red top SR20DET user should use diagram N02 also.

What to do with a bee-r launch controller?

Bee-R reccomend that you use this as a launch controller by attaching the wire to your handbrake. I attached my wire to the handbrake but use it to keep the revs up but not too high whilst on the handbrake mid drift. change rev1 and rev 2 settings and confirm that the limit changes when handbrake/switch is engaged.

Is the nengun Bee Racing rev limiter warranty?

Nengun Japan takes no responsibility if the Bee Racing Rev Limiter does not suit your vehicle. We ask you to seek the professional advice with a qualified tuning shop before purchase. This product must be installed by a qualified tuning shop, and there is no warranty what if it is installed by anyone else.