How do you reset the security on a 1998 Chevy Suburban?

How to Reset Passlocks on ’98 Chevy Trucks

1. Insert your registered key into the ignition. Try to start your Chevy truck.
2. Turn the key back to the “Run” position. The security light will start to flash off and on.
3. Turn your key clockwise to crank the ignition.

How do you reset the anti-theft system on a Chevy Suburban?

How to Reset the Passlock System on GM Cars

1. Insert your key in the starter, start you car as you usually would and let it stall. Keep the key in the “On” position.
2. Wait until the “Theft Sys” light on your dashboard stays on without blinking. This will take approximately 10 to 15 minutes.

How do I reset my Chevy security system?

The anti-theft is now reset. In a chevy silverado, you will try to reset the anti-theft system by turning the key on until the yellow lock goes out on the instrument panel for about 10 minutes. Turn the key off and do it 2 more times after 3 cycles, pull the key and put it back in.

How can I bypass PASSLock?

Thankfully this is an easy fix.

1. Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
2. Look at the dashboard and locate the theft system light.
3. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

How do I bypass passlock GM security system?

How do you override anti-theft system?

Insert the car key into your car’s ignition and turn it on. The car’s accessories will be activated but not the engine. Step 3: Do another check on the anti-theft light. If it isn’t blinking any longer, then turn the key over to the Off position and let it sit for a couple of minutes.

How do I bypass PASSLock GM security system?

How do I disable GM anti-theft system?

How to Disable a GM PassLock System

1. Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
2. Look at the dashboard and locate the theft system light.
3. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

What’s the name of the security system on a Chevy?

[1] Well, Passlock should be called the Great Immobilizer because not only does it stop thieves with no keys, it also stops owners with the right keys. GM introduced many security systems – VATS, Passkey, Passlock, but if your GM has a key without a chip in it, chances are it’s passlock.

What should I do if my GM security light is flashing?

Insert ignition key and turn to the “ON” position. Do not attempt to start the engine. Leave the key in the “ON” position for approximately 11 minutes. The security light will be steady on or flashing for the 11-minute period. Do not proceed to Step 2 until the security light turns off or stops flashing. 2.

How to permanently disable and remove GM security systems?

GM Security Systems are killing cars all over North America and the only final solution is to disable and remove them permanently. This is what NEWROCKIES Inc is all about.

How do you reset the PassLock on a 1998 Chevy truck?

Turn your key clockwise to crank the ignition. Wait for your truck to start, which confirms that you have successfully reset the passlock on your ’98 Chevy truck. Based in Chicago, Kenyonda Bradley has been writing for online publications since 2008.