How do you reset the PCM on a 2005 TrailBlazer?

To reset the check engine light in a 2005 chevy trailblazer locate the fuse panel in the engine bay under the hood. Remove the pcm ign and pcm bat fuses and wait for 5 minutes. Turn off the ignition, replace the fuses, and it should be reset.

Where is the factory amp in a 2005 Chevy TrailBlazer?

Registered. If you have bose, the amp is behind the rear passenger side trim panel.

How do you reset the computer on a 2004 TrailBlazer?

How to Reset the TrailBlazer Engine Light

1. Pop the hood open and locate the fuse panel cover in the engine bay. Release the cover from its retaining clips by pulling it up. Locate and remove the “PCM IGN” and “PCM BAT” fuses.
2. Wait at least 5 minutes. Turn the ignition off.

Where is the TCM located on a 2005 Chevy TrailBlazer?

The 2005 Chevy TrailBlazer transmission control module is located in the driver engine bay on the driver side in the front. The transmission fluid needs to be replaced every 30,000 to 60,000 miles.

How do you reset an engine control module?

Resetting your Engine Control Module through the Fuse Box When your vehicle has properly warmed up then you want to turn your vehicle back off and unplug both fuses, cut power by disconnecting the battery . After a few minutes all the old data should be reset so plug the fuses back in and turn your vehicle back on.

Where is the PCM located on a 2004 Chevy Trailblazer?

In the Trailblazer, the PCM is located on the driver’s side of the engine.

How do I hook up an amp to a factory stereo?

Usually, you’ll be installing a 4-channel amplifier with speaker-level inputs. The best way to connect it to a factory system is to tap into the stereo’s speaker outputs for the amp’s input signal. Then send the amp’s outputs back to the stereo’s harness, and on to the speakers through the factory wiring.

Does the 2004 TrailBlazer have Bluetooth?

But there is no bluetooth on these vehicles.

Where is the Transmission Control Module?

The transmission control module can often be found below the cover at the back of the transmission case. It should be just below the engine control module’s position. Sometimes it’s found under the center console in the interior or even under the hood near the battery or inner fender panel.

What are signs of a bad PCM?

7 Common PCM Failure Symptoms

• Your ‘Check Engine’ Light is On.
• Your Car Won’t Start or Starts Roughly.
• Sudden Loss of Gas Mileage.
• You Failed Your Emissions Test.
• Your Engine Stutters or Stalls.
• Erratic or Random Shifting.
• You’re Receiving a PCM-Related Error Code.
• What to Do If You Experience PCM Failure Symptoms.

What happens when engine control module goes bad?

Engine performance issues If the ECU has any issues, it may throw off the timing and fuel settings of the engine, which can negatively affect performance. A faulty ECU may cause the vehicle to experience a reduction in fuel efficiency, power, acceleration.

How much does it cost to reprogram PCM?

Prices could range from $80 to $150, depending on the service location you choose. The process takes around about half an hour, but keep in mind that most auto-electricians charge you for at least one hour of work. PCM reprogramming is also one of the few times we’ll recommend a dealership over an independent mechanic.

https://www.youtube.com/watch?v=yg1zcIfkUJY