How do you remove a transmission torque converter?

Turn the crank from the front crankshaft pulley bolt (CLOCKWISE facing the nose of the engine) a bit, remove a bolt, turn the crank a bit further, remove the next bolt, etc. until all the torque converter bolts are removed.

Where is the torque converter drain located?

Usually, the T-Converter can be found between the transmission drain pan and the engine flex plate on the car’s undercarriage.

Which is better torque converter or CVT?

Torque converter transmissions offer big torque at low revs, but are generally less efficient than single and dual-clutch transmissions. CVTs offer nearly an infinite number of gear ratios, meaning your engine is always working at peak efficiency, regardless of speed.

Can you replace a torque converter yourself?

If you choose to replace the torque converter yourself, the part itself will likely cost approximately $100-600, depending on the vehicle. But that means you’ll be dropping the transmission yourself. If you choose to take your issue to a shop, it will likely cost between $500-1,000.

How do you clean a torque converter at home?

This is done by putting a big breaker bar and socket or very large box end wrench on the pulley nut located at the front end of the crankshaft. Then remove the drain plug and let the converter drain into a drain pan. When it’s empty, retighten to the torque figure specified in the factory shop manual.

What kind of torque converter do I need for my 4L80E?

I went with a yank ss convertor for mine with a 3400 stall. Its only 9.5″ versus the stock 13″, but you need to get a ls1 flexplate too. I bought both just before christmas for 800 shipped. Great build your doing by the way.

Can a clogged transmission filter be a torque converter?

A restricted or clogged transmission filter makes the same whining noise as a faulty transmission pump. It’s crucial when diagnosing a transmission pump or a torque converter. Make sure the filter’s good before replacing the pump.

How does a torque converter affect a transmission pump?

It saves energy by reducing output without affecting speed. Transmission pumps are driven directly from the engine through the torque converter. The torque converter housing is mechanically attached to the engine’s crankshaft causing the pump to operate whenever the engine is running.

What kind of oil pump does a transmission converter use?

Transmission Oil Pump. Transmission oil pumps provide fluid pressure for the transmission and torque converter. The valve body regulates, controls, and directs the flow of pressurized transmission fluid. Gear and rotor-type are considered fixed displacement pumps. Most pumps today are variable displacement.