How do I turn off my Aube thermostat?

Aube TH132 does not have an off button, thus there is no straightforward way to turn it off when heating is not required. Set the temperature to minimum so the heating will have no reason to turn on.

What does LP mean on Aube thermostat?

During a power outage, LP (Low Power) appears for the first minute. Recovery mode on a thermostat is used to bring a space back to a normal occupied setpoint after having been set back usually by a schedule.

What temperature should I set my electric underfloor heating?

Underfloor heating temperature – what should I set it to? This varies from person-to-person, but generally 21°C is the ideal temperature for living areas. Bedrooms tend to be set slightly cooler at 18°C. You can set this using your underfloor heating control panel.

How do I reset my Aube thermostat?

Press the Mode button until Standby appears on the screen. reset and will then return to normal display.

How do you reset a thermostat on a floor?

Steps for Homeowner: At the thermostat location, press the reset button located on the bottom right side of the thermostat faceplate once to see if the error message and RED light will reset….The red light is on or blinking on the thermostat.

1. Cause.
2. The Ground Fault Circuit Interrupter (GFCI) has been triggered.

Why is my underfloor heating not getting hot?

Floor isn’t getting up to the desired temperature If your electric underfloor heating isn’t warm enough, you may need to adjust your thermostat settings or check the system’s power output. This could also be down to the insulation in your home – check this before installation.

What temperature should a heated floor be?

Radiant floors should not exceed 85 degrees F at the surface. 85 degrees is our skin temperature, so anything warmer starts too feel too warm. Floor coverings other than stone or tile REQUIRE a maximum temperature below 85 F. Most people are very comfortable between 75-80 degrees F.

What is the maximum temperature for underfloor heating?

50ºC
The maximum temperature for underfloor heating is typically 50ºC — and sometimes as low as 35º.

Do you need a manual for Aube Th232 af-230 thermostat?

Need a manual for your Aube TH232-AF-230 Thermostat? Below you can view and download the PDF manual for free. There are also frequently asked questions, a product rating and feedback from users to enable you to optimally use your product. If this is not the manual you want, please contact us.

Why did I buy an Aube thermostat?

The thermostat was bought to replace a thermostat which operates in a demanded floor temperature mode. The sensor became unserviceable, meaning that no heat was demanded by the thermostat. The Aube thermostat was purchased as it has an ‘Ambient’ mode which demands heat with regards to the air temperature of the room to be heated.

How to change the temperature on a Th232 thermostat?

E2 The floor sensor circuit is shorted. Replace the sensor. Press and hold the Clear button for 3 seconds. The current con- ( ctl). : If you have chosen the A or F mode, go to step 7. If you have ture while keeping the floo r temperature within desired l imits.

How to program a heatwell touch thermostat?

Learn how to program the Siemens RDE100 thermostat. Programming instructions for the Aube TH232 thermostat provided by Heatwell Ltd Heatwell Thermostat TR8100V programming instructions. Learn how to program the TR8100V touch thermostat thermostat.