How do I know if my dishwasher control board is bad?

To determine if the control or keypad is faulty, do the following test:

1. Unplug dishwasher or disconnect power.
2. Open the dishwasher door.
3. Open console and disconnect the keypad ribbon connection from the control (at P1).
4. Put console back together.
5. Plug in dishwasher or reconnect power.
6. Wait 5 seconds.

How do I reset my Whirlpool Quiet Partner 1 dishwasher?

How to Reset a Whirlpool Quiet Partner 1

1. Turn on the hot water at the faucet closest to your dishwasher and wait until the water becomes hot.
2. Leave the dishwasher door open as you reset it by pressing “heated dry,” “normal,” “heated dry” and “normal” in quick succession.
3. Run the dishwasher.

How to reset a whirlpool quiet partner 1?

How to Reset a Whirlpool Quiet Partner 1. 1 Step 1. Turn on the hot water at the faucet closest to your dishwasher and wait until the water becomes hot. The light on the control panel is 2 Step 2. 3 Step 3.

Are there any Whirlpool quiet partner dishwashers left?

Whirlpool Quiet Partner II Dishwasher Control Panel WHITE 8535121 8534979. CP20 Only 1 left! Only 1 left! Whirlpool Dishwasher Quiet Partner Door Latch W10142939 W10404409 FITS MANY!!

How can I Fix my Whirlpool dishwasher control panel?

The top control panel should pull away from the dishwasher. Pop off the plastic cover inside to expose the circuit board. Disconnect the 14 or 16 pin ribbon cable. Turn the power on. With the power on, carefully reconnect the ribbon cable. Reassemble your dishwasher.

What’s the highest setting on a Whirlpool dishwasher Control Board?

Close the panel and reattach the screws. Select “High” or “Pots & Pans” from the control panel board. The actual setting will depend upon the make but is the highest setting you can choose for the washing cycle. Select one of the “Heat” cycles for drying the contents of the dishwasher.