Where is the best place to mount a brake controller?

Find a suitable mounting location for the brake controller. On most vehicles, particularly large trucks and SUVs, the best place tends to be below and off to the side of the steering wheel. Here the controller will be easily visible but out of the way. It can also be mounted above the dash.

Do brake controllers have to be mounted level?

Expert Reply: Electric proportional brake controllers are required to be manually leveled by hand according to the parameters outlined in the installation instructions. Not all brake controllers have the same mounting range so you need to make sure you follow the instructions.

Can you mount a brake controller sideways?

DO NOT MOUNT CONTROLLER UPSIDE DOWN OR SIDEWAYS. WARNING: If the controller is mounted incorrectly, the deceleration sensor cannot operate correctly and may cause loss of braking.

How long does it take to install a trailer brake controller?

If you are going to an RV dealer that has experienced mechanics that have done hard wire installations several times in the past, I would say that the install time for the P-3 brake controller, # 90195, the 4-Way wiring harness, # 118390, and the brake controller installation kit, # ETBC7, will require 3-1/2 to 4 hours …

Why do brake controllers need to be level?

The reason this is important is because it cannot always be mounted flat (perfectly level) due to the shape of the interior on a vehicle. You would choose one that had a wider range for more mounting options. The Tekonsha P2, # 90885, can be mounted 360 degrees in the direction of travel and not tilted side to side.

Does a 7 pin connector control brakes?

What is difference between a 4 pin and 7 pin trailer connector? Expert Reply: A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer brakes (requires a brake controller in the vehicle), and a reverse light or auxiliary power circuit. There are other types of connectors as well.

Can you pull a trailer without a brake controller?

Can you pull a trailer with electric brakes without a controller? No. Without a brake controller your trailer’s electric brakes will remain inactive, you’ll be in breach of road rules and most importantly you wouldn’t be towing safely.

Where can I find a Ford Expedition brake controller?

Locate the OBDII port ( under steering wheel to right side) the pre wire conector will be connected to the metal bracket that holds the OBDII plug. Found it – thank you! Now which controller should I get? We sell a ton of brake controllers. The Tekonsha Prodigy line is our best seller. I strongly recommend going with a proportional controller.

Can a brake controller be mounted straight up?

There are limits as to how much the angle can be–it cannot be mounted pointed straight up in the air. Some brake controllers cannot tolerate (read: won’t work) mounting beyond a ten degree or so angle from horizontal. Check that out before purchase.

Where is the Ford P-3 brake controller located?

The Prodigy P-3 is a sweet little unit that mounts nicely (with two self-tapping screws) to the right of the steering column. The cable from the P-3 runs down, forward and then up into the Ford-supplied empty connector socket. I then used a few tie-ties to keep the cable up and out of the way of my leg.

Where can I find the impulse brake controller?

The IMPULSETMcame equipped with a quick connector plug wired to the back of the controller. OPTION: If your vehicle came equipped with a factory tow package, brake control function wires may exist under the vehicle dash (usually found under the driver side dash). Consult vehicle manual or call for location.