What should crossover be set at?

For main speakers: the recommended crossover frequency is 56-60 Hz (high pass). At this frequency, low-end bass, which can cause distortion, is filtered out. This crossover is the perfect middle ground between midrange bass capability and full-range sounds.

How do you set up a crossover frequency?

Setting The Crossover Frequency

1. Determine your speakers’ frequency range.
2. Set the crossover point around 10 Hz below the lowest frequency your speakers can produce without issue.
3. Once again, play some music.
4. Now set the gain of your subwoofer amp to its lowest possible value (a full counterclockwise position).

What is speaker crossover frequency?

The crossover frequency is the frequency at which sound transitions from one speaker to another. The crossover frequency for each speaker is generally set in the AV receiver by a processor, which filters low frequency content away from the speaker channels and redirects it to the subwoofer channel.

What should I set my low pass filter to?

As a general rule, the Low-Pass Filter should be set at a value approximately equal to (or below) 70% of your main speaker’s lowest frequency response. For example, your speaker’s frequency response goes down to 43Hz. 70% of 43Hz equals 30.1, so you should set the subwoofer’s low pass filter to 30Hz.

What should I set my HPF and LPF to?

You usually set the HPF with a steep slope say 24db/octave because you are trying to protect the sub from damage and a 12-18db/octave on the LPF because you want it to kinda “blend” in with your mids. The steeper the slope (db/octave) the less your sub will creep into the neighboring frequencies.

What is LFE setting on subwoofer?

LFE (Low Frequency Effect) – The discrete content sent to the subwoofer from a Dolby or DTS encoded audio track. ( The .1 in a 5.1 or 7.1 audio track) LFE + Main – The low frequencies output to the Subwoofer whether the speaker channels are set to Large or Small.

What is LFE crossover frequency?

Low-pass Crossover: The frequency below which your subwoofer will be working. Above this frequency, your main speakers reproduce frequencies for anything sent to the LFE or sub channel. The low-pass crossover is typically variable from 40Hz to somewhere around 160-200Hz.

Is 40 Hz low enough?

40 Hz is a very deep bass tone – the kind of rumbling tone that you feel in your body as much as you hear it. Small speakers, such as laptop speakers or small computer speakers, don’t go that low. If you try anyway, you will either hear nothing, or you will hear mostly – or only – distortion.

Does lower Hz mean more bass?

Do Lower Hz Mean More Bass? In any music setup, subwoofers are considered the best when it comes to reproducing the best punchy bass. One rule of thumb is that the lower the Hz, the more the bass you’ll get. In most cases, some of the most powerful subwoofers can reproduce deep bass at a frequency range of 20Hz.