What should be on an IV tubing label?

The only requirements for labeling include the name, strength, amount, and expiration date that are already on the manufacturer’s label, so relabeling is not necessary. ‘Individualized’ means only drugs prepared for a specific patient – not floor stock.

Why is labeling IV tubing important?

One of the most common reasons of hospital errors occur during the use and administration of intravenous (IV) medications. Unlabeled tubing increases the risk for unnecessary waste and increases hospital expenses. The goal of proper tubing labeling is to reduce the potential risk for medication errors.

What is the Y site on IV tubing?

Y-ports, also known as piggybacks, provide a second access point in patient IV tubing for additional IV medications to be given. The most common setup is to have maintenance fluids, such as normal saline or Lactated Ringer’s, infusing as the primary fluid. Open the package with the secondary tubing.

How do you label IV bag and tubing?

First and foremost, a label should address what the medication is, including the concentration and ingredients, the volume of the solution, and the medicine’s expiration date. It should then address the drip-rate.

What is the first step in the insertion of a peripheral IV line or saline lock?

The first step in the insertion of a peripheral IV line or saline or heparin lock is to obtain a physician’s order. IV therapy should only be initiated after this order is obtained, or as necessitated in an emergency situation.

What is a IV piggyback?

› An intravenous (I.V.) “piggyback,” or secondary infusion, is the administration of. medication that is diluted in a small volume of I.V. solution (e.g., 50–250 ml in a minibag) through an established primary infusion line. The piggyback can be administered by. gravity or by I.V. infusion pump.

How many days is IV tubing good for?

Many hospitals have protocols that require replacement of IV catheters every 72 to 96 hours, regardless of clinical indication.

When should IV tubing be changed?

Replace intravenous tubing, including add-on devices, no more frequently than at 72-hour intervals unless clinically indicated. Replace tubing used to administer blood, blood products, or lipid emulsions within 24 hours of initiating the infusion.

What is the difference between primary and secondary IV tubing?

Primary IV tubing is used to infuse continuous or intermittent fluids or medication. Secondary IV tubing: Shorter in length than primary tubing, with no access ports or backcheck valve; when connected to a primary line via an access port, used to infuse intermittent medications or fluids.

What happens if you don’t prime IV tubing?

Sounds obvious, but failure to adequately prime the drip chamber (which are usually marked with a fill line) will increase the likelihood of air bubbles making their way into the IV line. Especially if running at faster rates or with a shallow-fill of the drip chamber. Make sure you have actually primed the line.

How often should continuous IV tubing be changed?

every 72 hours
I.V. administration set changes. Change primary administration sets and any piggyback (secondary) tubing that remains continuously attached to them every 72 hours to minimize breaks in the closed administration system. Also replace them whenever the sterile fluid pathway may have been compromised.

https://www.youtube.com/watch?v=dFzUoidluKU